$75.99
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Anyone loading .416 Barrett knows the components don't come cheap, and a single mistake at the bench can feel like money down the drain. This RCBS collet is the piece that makes those mistakes fixable. It's the caliber-specific insert that lets the RCBS 1-1/2 inch-12 Bullet Puller grab and hold a .416 Barrett bullet so you can pull it free without wrecking the case underneath. Overcharged a round, seated a bullet too deep, or grabbed the wrong projectile? Drop this collet in, pull the round apart, and put your components back into service.
This is the collet only, not the complete puller assembly. It's built to work with the RCBS 1-1/2 inch-12 Bullet Puller body, which mounts in the AmmoMaster-2 or AmmoMaster .50 BMG press. That big 1-1/2 inch thread is what handles the size and heft of .416 Barrett brass, so if you're already running one of those presses for large-diameter cartridges, this collet slots right into the system you own. RCBS also offers a matching .50 BMG collet if you load both, and the puller body accepts either one.
Using it is refreshingly simple. Set the puller in your press, seat the collet, drop your cartridge in and raise the ram. Tighten the collet down onto the bullet, then lower the ram and the projectile slides free. Done right, you walk away with reusable brass, salvageable powder, and a bullet that's ready to load again. It's a smart move for pulling rare or expensive .416 projectiles during load development, or just cleaning up a batch that didn't go to plan.
Bottom line: if you're serious about .416 Barrett handloading and running an AmmoMaster press, this collet earns its spot in the drawer the first time it saves you a box of components.
No, this is the .416 Barrett collet only. It's designed to work with the separate RCBS 1-1/2 inch-12 Bullet Puller. You'll need that puller body and a compatible press to use it.
The collet and its 1-1/2 inch-12 puller body are designed for the RCBS AmmoMaster-2 or AmmoMaster .50 BMG press. The larger thread size is what handles big-diameter cartridges like the .416 Barrett. It won't fit a standard 7/8 inch-14 single-stage die station.
A collet puller grips the bullet directly in the press and pulls it straight out, which tends to be cleaner and more consistent for large cartridges. An inertia puller uses hammering motion to knock the bullet loose. For heavy .416 Barrett rounds, the collet system in a proper press gives you controlled, repeatable pulls.
Yes, that's the whole point. Pulling a round apart lets you salvage the brass, powder, and bullet for reloading. Always inspect your powder and primer carefully before reusing them, and wear eye protection while working at the bench.
| UPC | 076683094476 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 9447 |
| Shipping Weight | 0.1875 |
You must be logged in to post a review.
Reviews
There are no reviews yet.