$10.99
16 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Ruger 10/22 is a great little rifle, but that metal-on-metal clack every time the bolt slams home gets old fast, especially when you're running a suppressor. Powder River Precision's Bolt Buffer tackles that by replacing the factory steel bolt stop pin with a stainless steel pin wrapped in tough elastomer tubing. The result is a shock absorber sitting right where the bolt makes contact, so the action cycles quieter and feels noticeably smoother shot to shot.
Every time your 10/22 cycles, the bolt travels rearward and stops against that cross pin. Over thousands of rounds, hard blowback impact can start to peen the aluminum receiver holes into ovals. The elastomer sleeve on this buffer cushions that contact, taking the sharp edge off the impact and helping preserve the receiver over the long haul. Folks who shoot suppressed tend to love this kind of part most, since knocking down the mechanical clatter of the action makes a quiet gun even quieter and a lot more pleasant to run.
Installation is about as simple as it gets. Pull the old steel pin at the rear of the receiver and slide this one in its place. No tools beyond what you'd use for a basic takedown, no fitting, no permanent changes. If you ever want to go back to factory, it comes right back out during cleaning.
A lot of owners pair this with an upgraded bolt or a good extractor and report smoother running with fewer stovepipes and hung ejections. It's a small, inexpensive part that punches above its weight, and it's machined and assembled right here in the USA. If you've been eyeing a few 10/22 tweaks, this is one of the easiest and most satisfying places to start.
Yes, it's built specifically for the Ruger 10/22 and works with most clones that use the same bolt stop pin setup. It drops right into the receiver where the factory steel pin sits. If you have a very old pre-2005 rifle, it's worth double-checking your existing pin against the buffer before install.
Not at all. You just remove the factory steel bolt stop pin at the rear of the receiver and slide the buffer in its place. There's no fitting, no special tools, and no permanent modification, so you can always swap back to the original pin if you want.
It does. The elastomer sleeve cushions the metal-on-metal contact that creates that familiar bolt clack, so the action cycles noticeably quieter and smoother. Suppressor users especially notice the difference since it cuts down the mechanical noise that a can can't touch.
The factory part is a bare steel pin that lets the bolt slam against it metal-to-metal. This buffer keeps a stainless core for strength but wraps it in elastomer to absorb the impact, which helps protect the aluminum receiver from getting battered over time. It's a simple upgrade that also takes the edge off cycling noise.
| UPC | 686461784057 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | PRP-X-BB |
| Model |
You must be logged in to post a review.
Reviews
There are no reviews yet.