$15.00
3 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Every AR-15 has a dust cover, and most of them are plain as can be. The Phase 5 EPCSTAND ejection port door swaps that boring factory piece for something with a bit of attitude. It's a mil-spec steel plate finished in black parkerized coating and laser engraved with "Stand & Fight," so it looks right at home whether you run it on a defensive carbine or a build you've poured some love into.
Functionally, this door does the same job as any quality dust cover. When it's closed it seals off the ejection port, keeping dust, sand, lint, and general gunk away from your bolt carrier group. Pull the charging handle or send a round downrange and it flips open on its own, then snaps shut when you want it out of the way. Since it measures 3.10 inches, it's the standard length that fits AR-15 pattern upper receivers, so it drops right into place where your old cover lived.
This is a direct replacement for the standard AR-15 dust cover, which means the same hinge pin, spring, and c-clip your rifle already uses. Worth knowing before you order: the EPCSTAND is the cover only. Hardware is not included, so if you're building from scratch or your old parts are worn out, grab a hinge pin, spring, and c-clip kit while you're at it.
Installation is a straightforward gunsmithing job, though that little c-clip has earned its reputation for launching across the room. Take your time, work in good light, and a set of needle-nose pliers or a dedicated clip tool makes the whole thing much less frustrating. On some rifles you may need to pull the handguard and barrel nut to slide the hinge pin free, so plan accordingly. Once it's on, a quick function check to confirm it opens and closes with good spring tension, and you're done.
No, this is the dust cover only. Phase 5 sells it as the plate by itself, so if you're building fresh or your old hardware is worn, you'll want to pick up a hinge pin, spring, and c-clip kit separately. If you're just swapping the cover on an existing rifle, you can usually reuse the hardware that's already there.
It's built to the standard 3.10-inch length that fits AR-15 pattern upper receivers, so it drops right into where your factory dust cover sits. Just note that AR-15 and AR-10/.308 covers are different lengths, so this one is meant for AR-15 pattern rifles specifically.
The install itself is simple in concept, but the tiny c-clip that retains the hinge pin is famous for being fiddly and easy to lose. Work in good light, use needle-nose pliers or a dedicated clip tool, and take your time. On some rifles you may need to remove the handguard and barrel nut to get the pin out, so it's worth checking your setup before you start.
It's a mil-spec steel plate with a black parkerized finish, which is a durable, matte coating that holds up well to handling and the elements. The "Stand & Fight" text is laser engraved rather than printed, so it won't rub off over time.
| UPC | 813318020239 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | EPCSTAND |
| Model | |
| Product Type | Ejection Port Door |
You must be logged in to post a review.
Reviews
There are no reviews yet.