MTM The Bull Rifle Rest Gray – Adjustable Rifle & Handgun Bench Rest

Description

MTM built The Bull for one job and it does it well: holding your rifle steady while you sight in a fresh scope or work up a load. The two-piece polypropylene frame slides apart and locks in anywhere between 18.3 and 26 inches, so whether you're running a compact carbine or a long-barreled magnum, the front and rear cradles line up where you need them. A wide, planted stance and slip-free rubber feet keep the whole thing from creeping around on the bench between shots.

What Makes The Bull Worth Keeping on the Bench

Molded rubber pads at the front and rear contact points are non-marring, so your stock and forend stay scuff-free even after a long session. Front elevation runs off a handwheel, meaning you dial your point of aim up or down with a few quick turns and no tools. That handwheel setup gives you repeatable adjustments, which matters a lot when you're chasing a tight zero or comparing groups between different loads.

Setting Up The Bull Rifle Rest at the Range

Assembly is straightforward and takes a minute or two out of the box. Because it's molded from polypropylene, the rest stays light enough to grab with one hand, which is a nice change from hauling around a heavy cast-metal rest. A common trick from folks who shoot hard-recoiling calibers is to drop a shot bag or sandbag across the base for extra ballast, which settles heavier rifles right down and tames the bounce.

Built in the USA for Real Range Work

The Bull is proudly made in America and comes in at right around 4.6 pounds, so it packs easily in a range bag or truck bed. It handles both rifles and handguns, making it a practical all-around bench rest for zeroing optics, checking function, and running through new ammo. For anyone who spends time behind the bench, it's a solid, no-nonsense platform that earns its spot.