$54.99
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The FightLite MCR Extractor is the factory-original claw that grabs the case rim and yanks spent brass clear of the chamber every time your MCR cycles. It's a small part with a big job, and since the MCR runs a beefier setup than a standard AR, it uses its own dedicated extractor rather than a generic AR-15 piece. This is manufacturer part number 15068, made specifically for the FightLite MCR bolt.
The MCR isn't a modified AR upper. It's a purpose-built, closed-bolt, belt-fed system running a short-stroke gas piston that drives a heavier bolt carrier. The bolt itself is a 6-lug rotating design that's stouter than a typical AR-15 bolt and built for sustained fire. Because of that, the extractor is sized and shaped for the MCR bolt assembly and won't cross over from a standard AR parts bin. When you're feeding from M249 SAW links or a STANAG mag, reliable extraction is what keeps the whole cycle honest.
Extractors are a wear item on any firearm, and one that runs hot with a belt gets worked harder than most. If you're chasing down failure-to-extract issues, seeing chewed case rims, or just building out a spare parts kit for a long range day, having a fresh 15068 on the shelf is smart insurance. It pairs naturally with the MCR extractor spring and extractor pin, so a lot of folks grab all three when they're freshening up the bolt.
This is a genuine FightLite Industries component, not aftermarket. It's built from the same materials and to the same spec as the extractor that came in your MCR from the factory, so fit and function match exactly. When you're maintaining a system like the MCR, sticking with factory parts takes the guesswork out of it.
The extractor is the small hooked claw on the bolt that grabs the rim of a spent cartridge and pulls it out of the chamber as the action cycles. On a belt-fed system like the MCR that can run hard and hot, reliable extraction is critical to keeping the gun feeding and firing without stoppages. A worn extractor is a common cause of failure-to-extract issues.
No. The MCR uses a purpose-built 6-lug bolt that's heavier and different from a standard AR-15 bolt, so this extractor is made specifically for the MCR bolt assembly. It won't interchange with generic AR-15 extractors, and a standard AR extractor won't work in your MCR.
Yes. This is manufacturer part number 15068, a factory-original FightLite Industries component made in the USA. Using factory parts on the MCR means fit and function match the original exactly, which takes the guesswork out of maintenance.
The extractor works together with the extractor spring (15070) and the extractor pin (15069) inside the bolt assembly. If you're doing a full refresh of that area, many owners replace all three at the same time since they're all wear-related. For a straightforward extractor swap, you'll want the pin to seat it in the bolt.
| UPC | 854118002940 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 15068 |
You must be logged in to post a review.
Reviews
There are no reviews yet.