$69.99
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Hard-kicking guns wear you out fast, and a good recoil pad is one of the cheapest ways to fix that. The Limbsaver Nitro Grind-To-Fit Recoil Pad in Medium gives you a blank slate to work with, letting you shape the pad to your exact stock profile for a clean, custom look instead of a bolt-on that never quite lines up. It measures 1-1/2 inches thick, comes in black, and is built to tame the punch from magnum rifles, heavy slug loads, and everything in between.
The heart of this pad is Limbsaver's NAVCOM material, short for Noise and Vibration Control Material. Rather than just cushioning the blow, it works across a wide range of frequencies to dissipate the energy before it reaches your shoulder. Limbsaver rates it at up to 70 percent reduction in felt recoil, and it also cuts down muzzle jump, which helps you settle back onto target quicker for follow-up shots. The outer surface grips your shoulder and stays put even in wet weather, so your gun mount stays consistent.
This medium pad is built around a 1-1/2 inch length of pull and starts at roughly 5-3/32 by 1-13/16 inches. From there you can grind it down as small as about 4-1/4 by 1-5/16 inches, which covers a huge range of standard rifle and shotgun stocks. If you're unsure about fit, Limbsaver offers printable templates on their site so you can check dimensions and screw hole spacing against your stock before you ever pick up a tool.
This is a project pad, and that's the whole point. Fitting it right means mounting it to the stock, scribing your line, and taking it down on a belt sander with a fresh belt. Go slow and keep it cool so the rubber doesn't gall or chunk. Stay off your scribe line with the coarse belt, then switch to a finer grit to blend the sides from heel to toe. If you're not comfortable running a grinder, this is a quick job for any gunsmith, and it's a favorite pad among custom shops for exactly that reason.
For the cleanest results, yes. The Grind-To-Fit design is meant to be shaped to your specific stock so the pad lines up flush with no overhang. Some folks do run the pad slightly oversized, but grinding it to match gives you the best look and the most consistent shoulder contact.
The medium starts at about 5-3/32 by 1-13/16 inches and can be ground down to roughly 4-1/4 by 1-5/16 inches, so it covers most standard rifle and shotgun stocks. It's built around a 1-1/2 inch length of pull. If you want to confirm before ordering, Limbsaver publishes printable templates you can hold against your stock.
Limbsaver rates the NAVCOM material at up to 70 percent reduction in felt recoil. Results vary by gun and load, but users shooting hard-kicking magnums often report the difference is dramatic enough to make range sessions comfortable again. It also helps cut muzzle jump for faster follow-up shots.
If you have a belt sander and a steady hand, you can do it at home. Mount the pad, scribe your line, and grind slowly with a fresh belt so the rubber stays cool and doesn't chunk. If you'd rather not risk it, any gunsmith can fit one quickly since these pads are a shop favorite.
| UPC | 697438105386 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 10538 |
| Color | Black |
| Model | |
| Product Type | Recoil Pad |
| Shipping Weight | 0.6 |
You must be logged in to post a review.
Reviews
There are no reviews yet.