$38.99
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Limbsaver Classic Precision-Fit Recoil Pad is built to replace the factory pad on the Browning A-Bolt synthetic stock, and it's a big upgrade in comfort for anyone putting rounds downrange all day. Instead of a generic slip-on that bulks up the butt, this one is molded to match the contours and screw pattern of the A-Bolt so it sits flush and looks like it came from the factory. The heart of it is Limbsaver's NAVCOM material, a proprietary noise and vibration control rubber that absorbs a wide band of frequencies and turns harsh recoil energy into a soft, spread-out push against your shoulder.
Limbsaver rates this pad to knock down as much as 70 percent of felt recoil, and it also works to tame muzzle jump so you settle back on target faster between shots. That matters most on hard-kicking magnum chamberings and long sight-in sessions, where flinch tends to creep in and wreck your groups. Less pounding on the shoulder means you shoot longer, more comfortably, and usually more accurately.
This is a two-screw install using the #8 steel screws included in the package. You feed the screws through the holes in the face of the pad, then run them down with a lubricated Phillips driver until they seat against the backing plate. A dab of gun oil or even cooking oil on the driver shaft helps it slide through the soft rubber without a fight. The oval-shaped holes in the backing plate give you a little wiggle room to line everything up clean before you snug it down. Most A-Bolt owners can knock this out at the kitchen table in a few minutes.
The pad adds about 1 inch to your length of pull, which is worth keeping in mind if you already have your stock dialed in. The black rubber has a non-slip surface that grips your shoulder and holds up to rain, cold, and rough field conditions. Limbsaver has been building these in the USA since 1991, and their recoil pads have a well-earned reputation with hunters and target shooters alike.
This is the Model 10003, which Limbsaver designs specifically for the Browning A-Bolt synthetic stock and the BPS Youth/Ladies wood stock. Because factory stock dimensions can vary slightly between production runs, Limbsaver recommends checking the fit with their printable template before installing. If your stock matches the pad's contour and screw spacing, it drops right in.
It mounts with two screws using the #8 steel hardware included in the package. You push the screws through the holes in the face of the pad, then drive them down with a lubricated Phillips screwdriver until they seat against the backing plate. The oval-shaped holes in the base give you a bit of room to align the pad before tightening it fully.
Limbsaver rates the Classic Precision-Fit pad to reduce up to 70 percent of felt recoil thanks to their NAVCOM vibration-dampening material. It also helps cut muzzle jump so you recover onto target faster. Real-world results depend on your cartridge and rifle weight, but the difference on a hard-kicking A-Bolt is noticeable.
Yes, it adds about 1 inch to your length of pull. If your rifle already fits you well, factor that into your setup, since a longer LOP changes how the rifle mounts to your shoulder. For many shooters that extra reach is a comfortable fit, but it's worth checking against your shooting stance.
| UPC | 697438100039 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 10003 |
| Product Type | Recoil Pad |
| Shipping Weight | 0.4 |
You must be logged in to post a review.
Reviews
There are no reviews yet.