Description
This is Lee Precision's C324-175-1R, a two-cavity bullet mould that drops a .324 inch diameter, 175 grain round nose bullet. It's built for folks who run 8mm cartridges and want to feed their own cast lead instead of paying for factory projectiles every range trip. The bullet carries a 1 ogive radius profile and a gas check base, so you can push it a little harder without leading up your bore.
What the C324-175-1R Casts
Every pour gives you two bullets at once, which adds up quick when you're filling trays for a loading session. The .324 diameter and 175 grain weight make it a natural fit for 8mm Remington Magnum and similar 8mm class rounds, though you'll always want to slug your bore and check your reloading manual for load data that matches your rifle. The gas check design means you crimp a copper check onto the base before sizing, and that little step pays off with cleaner barrels and better accuracy when you're running warmer loads.
Why Shooters Reach for Lee Aluminum Moulds
Lee machines these blocks from aluminum for a reason. The cavities are lathe bored for tight, consistent roundness, and the aluminum heats up and cools down faster than old iron or steel moulds, so you're dropping good bullets after just a few casts. Aluminum won't rust sitting in your loading room either, and the lighter weight means less hand fatigue during a long casting run.
This mould comes with handles and the sprue plate attached, so it's ready to clamp in and get to work once you degrease it. A lot of casters give the cavities a light smoke from a candle or butane flame to help bullets drop free, which is a tried and true trick with Lee blocks. Keep your melt at a steady temperature and don't overheat the aluminum, and this mould will turn out clean, uniform bullets for a very long time.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90274
- Model: C324-175-1R
- UPC: 734307902742
- Bullet Diameter: .324 inch
- Bullet Weight: 175 grains
- Bullet Profile: Round Nose, 1 Ogive Radius
- Base Design: Gas Check
- Cavities: Double (2)
- Caliber: 8mm (.324)
- Block Material: Aluminum, CNC/lathe bored cavities
- Country of Origin: United States
What’s Included
- Lee C324-175-1R double cavity bullet mould block
- Mould handles
- Sprue plate
Frequently Asked Questions
What cartridges does the Lee C324-175-1R mould work with?
It casts a .324 diameter 175 grain round nose bullet suited for 8mm class cartridges like 8mm Remington Magnum. Since bore diameters vary between rifles, slug your barrel and confirm sizing before loading. Always pull load data from a current reloading manual for your specific setup.
Does this bullet require a gas check?
Yes, the C324-175-1R is a gas check design, so you'll crimp a copper gas check onto the base before sizing. The gas check helps protect the bullet base and reduce leading when you're running warmer, higher velocity loads. It's a simple extra step that pays off in cleaner barrels and better accuracy.
Are handles included with this Lee mould?
Yes, this double cavity mould ships with the handles and sprue plate, so it's ready to clamp in and cast once you degrease it. You won't need to buy a separate handle set to get started.
Why are Lee moulds made from aluminum instead of iron?
Aluminum blocks heat up and cool down faster than iron or steel, so you can usually drop good bullets after only a few casts. The aluminum also won't rust sitting on your bench and weighs less, which cuts down on hand fatigue during long casting sessions. Lee bores the cavities on a lathe for consistent roundness and sizing.




Reviews
There are no reviews yet.