Description
The Lee Collet Neck Sizer Die takes a different approach than a standard full-length sizer. Instead of forcing the case neck down over an expander ball, it uses a collet to squeeze the neck inward against a precision-ground mandrel. The result is a neck that's sized true to the mandrel with minimal runout, which translates to better bullet alignment and the kind of consistency that shows up on paper. Since you're only working the neck and not the body, your brass stretches less and holds the custom fit it got from being fire-formed in your chamber.
How the Lee Collet Neck Sizing Die Works
The collet closes around the case neck as you run the press through its stroke, pressing the brass against the internal mandrel to set a round, concentric inside diameter. Because nothing is dragging the neck over an expander on the way out, there's far less chance of pulling things out of alignment and the brass work-hardens much more slowly. Neck tension typically lands right around .002 inch, which plenty of handloaders find is enough to shoot accurately without crimping. One nice side benefit: no case lube needed on the necks, so there's no sticky cleanup step afterward.
Getting the Most From Your .223 Collet Die
This die shines when you're reloading brass that's been fired in the same rifle it's going back into, which is why it's a go-to for bolt action and single shot .223 Rem and 5.56 NATO shooters. Setup is adjustable, so you can dial the amount of neck sizing to match the spring-back of your particular brass. Pairing it with a Lee breech lock bushing makes it a set-and-forget tool on the press. Keep in mind this is the neck sizing die on its own, so you'll still want a seating die to complete your loading sequence.
For anyone fire-forming brass and chasing tight groups out of a precision .223, the Lee Collet Neck Sizer is one of the most cost-effective ways to squeeze real accuracy out of your handloads.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number (MPN): 90954
- UPC: 734307909543
- Caliber: .223 Rem / 5.56 NATO
- Product Type: Collet Neck Sizing Rifle Die
- Die Type: Neck Sizer
- Die Series: Collet
- Material: Steel
- Gun Type: Rifle
- Lubrication Required: No
- Pieces In Set: 1
What’s Included
- Lee Collet Neck Sizing Die (.223 Rem / 5.56 NATO)
- Lock ring
- Instructions
Frequently Asked Questions
Does the Lee Collet Neck Sizer Die require case lube?
No, it does not. The collet squeezes the neck against the mandrel rather than dragging it over an expander ball, so there's no need to lube the necks. That saves you a step and means no sticky residue to clean off afterward.
Is the Lee Collet Neck Sizing Die good for AR-15s and semi-autos?
Neck sizing in general is best suited for bolt action and single shot rifles, since the brass is only sized at the neck and keeps the body fit from your chamber. It works great for a .223 bolt gun where you're reloading brass fired in that same rifle. Many handloaders do run neck-sized brass through semi-autos with light tension, but full-length sizing is usually the safer choice for reliable autoloader feeding.
Does this Lee Collet Die come with a seating die?
No. This is the collet neck sizing die on its own, so it handles the neck sizing step only. You'll need a separate bullet seating die to finish loading your rounds.
How much neck tension does the Lee Collet Neck Sizer Die produce?
It commonly sets around .002 inch of neck tension, which many reloaders find plenty for accurate shooting without crimping. The exact amount can vary with the spring-back of your particular brass. The die is adjustable, so you can fine-tune the amount of sizing to match what you're loading.





Reviews
There are no reviews yet.