Description
The Lee 90703 Collet 2-Die Set is built for the handloader who wants the tightest groups out of their .257 Roberts without fussing with lube pads or sticky cases. Instead of sizing the whole case like a full length die, the collet die squeezes the neck against a hardened steel mandrel to create a precisely aligned case neck while cutting runout way down. That consistency at the neck is what shows up on paper, and it's the reason a lot of folks swear by the collet system for precision bolt gun loads.
How the Lee Collet .257 Roberts Set Works
The collet die uses a four-piece collet that closes around the neck and presses the brass to the mandrel, so the inside of the neck gets sized to match your bullet with minimal distortion. Because you're only working the neck, no case lubrication is required and there's nothing to wipe off afterward. Sizing only the neck also preserves the fire-formed fit of the body and shoulder to your chamber, which is why this set is intended for brass that's already been fired in your rifle.
Dead Length Seating in the .257 Roberts 2-Die Set
The second die is Lee's dead length bullet seater, the same easy adjust seater found across their rifle die sets. It lets you dial in a consistent seating depth every time, and since the collet system does not crimp, you're free to seat bullets out close to the lands where many .257 Roberts loads shoot their best. That bullet-to-rifling contact provides the shot start pressure a crimp would normally give you.
Why Reach for the Lee 90703 Collet Set
Neck sizing with a collet is easy on your brass, and Lee backs the system with a smallest-group-or-your-money-back guarantee. It's a straightforward, no-lube way to turn out accurate ammo for a bolt action .257 Roberts. Keep in mind this is a neck-sizing setup, so it's geared toward cases fired in your own gun rather than range pickup brass or loads headed for autoloaders, slide, or lever action rifles.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90703
- Model: Collet
- UPC: 734307907037
- Caliber: .257 Roberts
- Product Type: Collet 2-Die Set w/ Shell Holder
- Die Material: Steel
- For Use With: Rifle Cartridge
- Sizing Style: Neck Sizing (Collet)
- Case Lube Required: No
- Also Fits: .257 Ackley Improved
What’s Included
- Collet Neck Sizing Die
- Dead Length Bullet Seating Die
- Shell Holder
- Powder Dipper
- Load Data / Charge Table
- Storage Box
Frequently Asked Questions
Does the Lee 90703 Collet Set require case lube?
No. The collet die sizes only the neck by pressing it against a mandrel, so there is no lube needed and nothing to clean off your cases afterward. That's one of the big conveniences of the collet system compared to full length sizing.
Does this Collet 2-Die Set crimp the bullet?
No, the collet set does not crimp. It includes a dead length bullet seater that sets a consistent seating depth, and the design is meant for seating bullets close to the rifling for accuracy. If you want a crimp, Lee offers a separate Factory Crimp Die for .257 Roberts.
Can I use range brass or any .257 Roberts cases with these dies?
The collet die neck sizes only and preserves the fire-formed fit of the case body and shoulder, so it's intended for brass that has already been fired in your own rifle. It is not recommended for autoloaders, slide action, or lever action guns since those typically need full length sizing for reliable feeding.
Will the Lee 90703 work for .257 Ackley Improved?
Yes. Lee's .257 Roberts collet die also handles .257 Ackley Improved, so the same neck sizing die covers both chamberings. The dead length seater in the set works with standard .257 bullets as well.





Reviews
There are no reviews yet.