$79.20
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
L.E. Wilson has been building precision reloading tools for decades, and the chamber-type bullet seater is one of the designs that earned them a loyal following among benchrest and precision crowd. This one is cut for the .243 Winchester (part number BS24-WIN), turned from machined polished steel rather than cast, and each die is hand reamed to the correct headspace so your cases sit exactly where they should.
The whole point of this die comes down to alignment. Instead of relying on a sliding sleeve or a loose-fitting conventional die, the chamber-type body fully captures both the case and the bullet before anything moves. A close-fitting seating stem then pushes the bullet straight down into the case mouth, which cuts out the rocking and tilting that drives up runout in standard 7/8-14 seaters. The result is straighter, more concentric loaded rounds, and that consistency is exactly what shows up on paper when you are chasing small groups.
Seating depth adjustments are made with the screw inside the cap, giving you fine control over your overall length as you work up a load. Because the die runs with an arbor press or even a soft-faced mallet, it is compact and portable enough to bring right to the range, so you can tweak your seating depth and test COAL on the spot. Keep in mind this is a hand die, so it is meant for an arbor or hand press rather than a conventional threaded press.
If you load .243 Winchester for varmints, target work, or light big game and you want factory-beating concentricity, this is the kind of tool that pays off round after round. The tight tolerances and simple, rugged design mean it will keep producing accurate ammo for a very long time. Made in the U.S.A.
No, this is a hand die designed to run with an arbor press or a soft-faced mallet. It is not made for a conventional 7/8-14 threaded press. Most precision reloaders pair it with a dedicated arbor press for clean, repeatable seating.
The die fully captures both the case and the bullet before seating, holding them in alignment inside a machined cavity. A close-fitting stem then pushes the bullet straight into the case mouth without the rocking you can get in looser conventional dies. That translates to lower runout and more concentric loaded rounds.
Seating depth is adjusted with the screw inside the cap, which lets you fine-tune your overall length. Since the die is compact and portable, you can bring it to the range and dial in your ideal COAL as you test loads.
This is a bullet seating die only, so it does not size brass. You will want a separate sizing die to prep your .243 Winchester cases before seating bullets with this one.
| UPC | 815145021250 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BS24-WIN |
| Shipping Weight | 1.0 |
You must be logged in to post a review.
Reviews
There are no reviews yet.