L.E. Wilson 6mm GT Fired Case Holder (Standard) CH-6GT

Description

If you shoot 6mm GT and you want your trimmed brass to come out uniform every single time, the case holder is where that consistency starts. The L.E. Wilson 6mm GT Fired Case Holder (Standard) is the piece that marries up with your L.E. Wilson Case Trimmer and keeps each case locked in place while you work. Instead of grabbing the case head, it supports the brass by its own body taper, cradling the case much like a rifle chamber does. That design is a big part of why the Wilson system has such a loyal following among precision reloaders.

How the 6mm GT Case Holder Keeps Cuts Square

The holder seats into the trimmer's rail system right alongside the cutter housing, so the case mouth meets the blade perfectly aligned. The result is a square, concentric trim without the wobble or runout you can run into with pilot-guided setups. Beyond trimming to length, the same holder pulls double duty for primer pocket reaming, neck reaming, and case mouth deburring when paired with Wilson's Uniform Deburring Tool. Using it is simple: drop the case in, give the head a light tap on a firm surface, and set it in the trimmer. When you're done, a quick tap on the case mouth pops it back out.

Picking the Right 6mm GT Holder

Holder sizing comes down to the taper and diameter of the case body along with its length, which is why these are caliber specific. This is the FIRED version, meant for neck sized 6mm GT brass. Wilson does make a separate New Case holder for 6mm GT, so if you're running new or full length resized brass, that's the one to reach for. Matching the holder to how your brass is sized is what keeps the fit snug and the trims repeatable.

Machined from billet steel and coated with a protective finish, this holder is built to log years on the bench. It carries L.E. Wilson's reputation for precision tooling, and like the rest of their lineup, it's made right here in the USA.