$17.60
5 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The L.E. Wilson Case Holder in the CH-2250 pattern is the piece that makes a Wilson Case Trimmer sing. It cradles your fired, neck-sized brass by the body taper rather than the case head, which keeps the case aligned the same way a rifle chamber does. That alignment is the whole point here: when the case sits square, the trim comes out square, and your trim-to-length stays consistent round after round. This standard holder covers the 22-250 Remington family, and the same body profile also fits 250 Savage and 6mm International.
Beyond length trimming, this holder earns its keep during the rest of your case prep. It locks the case in place for primer pocket reaming, neck reaming, and deburring when you pair it with Wilson's Uniform Deburring Tool. Cases press in and back out of the holder, and a lot of folks keep a wooden dowel handy to tap the brass free without marring anything. It's a simple, no-fuss design that does one job and does it right.
L.E. Wilson has been machining case holders and trimmers since the 1930s, and the fit and finish show it. This one is turned from steel with a polished surface, so it shrugs off bench abuse and holds its tolerances for the long haul. Because Wilson doesn't list a separate "New Case" holder for this particular grouping, this standard holder is all you need for your neck-sized brass in these calibers.
Keep in mind this is a cartridge-specific holder sized to the 22-250 Remington body, so grab the matching holder for any other calibers on your loading bench. Made in the U.S.A. and built to outlast the rifle it feeds.
This standard holder is cut for the 22-250 Remington body profile, and the same taper also handles 250 Savage and 6mm International. Wilson sizes holders by case diameter and length, so these three share one holder. For any other cartridge, you'll want the matching holder sized to it.
This is a Standard (Fired) holder intended for neck-sized cases. Since Wilson doesn't make a separate "New Case" holder for this caliber grouping, this one covers your neck-sized brass for these cartridges. It grips the case by body taper rather than the head.
Yes, the CH-2250 is designed to run with the L.E. Wilson Case Trimmer, which is sold separately. The holder cradles the case while the trimmer does the cutting. It also supports the case for primer pocket reaming, neck reaming, and deburring with Wilson's Uniform Deburring Tool.
Cases press into the holder and need to be pushed back out after trimming. Many reloaders use a wooden dowel to tap the brass free without scratching or denting it. It's a quick step once you get the rhythm down.
| UPC | 857949005265 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | CH-2250 |
| Shipping Weight | 0.3 |
You must be logged in to post a review.
Reviews
There are no reviews yet.