L.E. Wilson Case Gage 30-06 Springfield (CG-3006)

Description

The L.E. Wilson Case Gage for 30-06 Springfield is the kind of simple, do-one-thing-well tool that earns a permanent spot on the reloading bench. It's a one-piece, non-adjustable cylinder gage machined for fired and resized 30-06 brass, letting you quickly reference where your cases sit against minimum chamber dimensions. Drop a case in, set it on a flat surface, and you can read overall trim length by eye or measure headspace with a set of calipers or a depth micrometer.

What the 30-06 Case Gage Actually Checks

This gage reads two things that matter for safe, consistent bottleneck reloading: minimum and maximum case length, and minimum and maximum headspace from the datum on the shoulder back to the head. It's the go-to reference for setting up a standard 7/8-14 full length sizing die, since one of the easiest mistakes in reloading is bumping the shoulder back too far and overworking your brass. Worth noting, it does not measure body diameters, so it's purely a length and headspace reference rather than a full body-dimension check.

Dialing In Your Sizing with the Wilson Gage

The workflow most reloaders settle into is straightforward. Take an initial headspace reading on a fired case, then slowly adjust your full length sizer until you see roughly a .001 to .002 inch drop in headspace. That gets your shoulder bumped just below the chamber's headspace for a snug, repeatable fit that shoots well and keeps case life long. Flip the gage with the head down and sight across the top to check whether your cases need a trim.

Built to Last on the L.E. Wilson Bench

L.E. Wilson has been turning out precision reloading tools for well over 80 years, and this gage carries that reputation. It's made in the USA from steel with knurling in the middle for grip, so it holds its dimensions and won't wear out with regular use. Pair it with a caliper or the Wilson case gage depth micrometer and you've got a dead-simple, repeatable system for 30-06 case prep.