$48.00
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
A baffle strike is one of the most expensive mistakes you can make with a suppressor, and the frustrating part is that most of them are preventable. Threads, muzzle devices, and mounts can stack tolerances in ways you cannot see just by eyeballing the setup. The HUXWRX .338 Alignment Rod gives you a fast, reliable way to confirm your bore, muzzle device, and suppressor are all lined up along the same path before that first shot ever leaves the barrel.
With the firearm cleared and the suppressor mounted, you insert the rod through the front of the can and down into the bore. The rod is sized for .338 caliber bores, which also makes it a natural fit for 8.6 Blackout, .338 Lapua, and .338 Norma builds. If the rod passes cleanly through the suppressor without dragging or contacting the baffles, you are concentric and good to go. If it hangs up or sits visibly off center, you just caught a problem before it cost you a can. The bright tip on the end gives you a clear visual reference against the bore, so there is no squinting or guesswork involved.
The rod itself is carbon fiber, so it is light, rigid, and will not scratch up your bore or baffles the way a steel rod could. At 18 inches long with a published straightness spec of 0.003 inch, it is long enough to reach through full size .338 suppressors and precise enough that you can trust what it tells you. HUXWRX recommends verifying barrel to suppressor alignment on any new build before it is fired, and that is good advice whether you are running one of their cans or anything else threaded onto a .338 barrel. For the cost of this tool versus the cost of a damaged suppressor and barrel, it is one of the easiest calls you will make. Keep it in the range bag and run the check every time you change hosts or mounts.
First, verify the firearm is completely clear. Mount your suppressor as you normally would, then insert the rod through the front of the can and into the bore. If the rod passes through centered without touching the baffles or end cap, your alignment is good. If it drags or sits off center, pull the can and figure out what is causing the misalignment before firing.
Yes. The rod is sized for .338 caliber bores, which covers 8.6 Blackout, .338 Lapua Magnum, and .338 Norma Magnum among others. If your bore diameter is in the .338 family, this is the right rod for the job.
Not at all. The rod works with any suppressor or muzzle device on a .338 caliber barrel, regardless of brand. It is simply checking that the path through the can lines up with the bore, so it is a useful tool for any suppressed .338 setup.
Carbon fiber is rigid enough to hold a tight straightness spec, in this case 0.003 inch over its 18 inch length, while being far lighter and gentler on your bore and baffles than steel. You get an accurate reading without worrying about marring the crown or the inside of your suppressor.
| UPC | 706433763832 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 2263 |
| Caliber/Gauge | .338 Caliber |
| Color | Black |
| Length | 20.9000 |
| Model | |
| Package Height | 1.55 |
| Package Width | 1.55 |
| Product Type | Tool |
| Shipping Weight | 0.1 |
You must be logged in to post a review.
Reviews
There are no reviews yet.