Hornady Unprimed Brass .41 Rem Mag Cartridge Cases (87411)

Description

If you load your own .41 Magnum, you already know the case is where accuracy starts, and Hornady treats it that way. These are new, unprimed .41 Remington Magnum cases produced in smaller lots that meet strict quality standards, which means you're starting with a clean, consistent foundation instead of mixed-headstamp range pickups. This is component brass only, not loaded ammunition and not primed, so it's ready to go straight into your prep routine.

What Sets This .41 Rem Mag Brass Apart

Hornady measures these cases for tight wall concentricity, which helps the bullet seat straight in both the case and the chamber. That same concentricity contributes to a more uniform release of the bullet when the round fires, and that translates to steadier velocities downrange. Uniform case wall thickness is something benchrest crowds have chased for decades, and Hornady manufactures to tight tolerances to keep that element consistent from case to case.

Getting the Most From Your Hornady .41 Magnum Cases

Every case is held to consistent weight and internal capacity, so a box from one lot behaves like a box from another in the same caliber. That consistency pays off when you're working up a load, because your charges and pressures stay predictable instead of jumping around on you. Hornady also runs its brass through a pressure calibration test to confirm uniform case expansion during firing.

Because the brass is built with extra care rather than treated as a throwaway commodity, you can expect to get a good number of reloads out of each piece before it's done. For single-action revolver loads, hunting handgun work, or just keeping your .41 Mag fed with quality components, this is a dependable starting point. Made in the USA, and ready for your sizing die, primer, powder, and bullet of choice.