Description
This is the .315 inch bushing from Hornady's Match Grade lineup, a 7mm caliber neck sizing bushing that handles one of the most important jobs on the bench: setting consistent neck tension. Rather than squeezing your necks down to a one-size-fits-all SAAMI minimum, this interchangeable bushing lets you size the case neck to the exact dimension your brass and chamber call for. That means less working of the brass, better case life, and the kind of repeatable neck tension that shows up on paper when you're chasing tight groups.
The bushing is machined from polished steel and carries an inside diameter of 0.315 inches. It sits in the die body as a free-floating, self-centering piece, which is the whole trick here. Because it finds its own center on every stroke, your necks stay concentric and you avoid the over-sizing that beats up brass over time. Hornady offers these bushings in fine increments across the range, so once you measure a loaded round and work out your target dimension, you can pick the size that lands right where you want it.
Where the .315 Match Grade Bushing Fits
This bushing works in both the Match Grade full-length sizing die and the Match Grade neck sizing die. The full-length version sizes the case body, bumps the shoulder, and sizes the neck using the installed bushing, while the neck die bumps the shoulder and sizes only the neck. Swapping bushings is quick thanks to the knurled spindle lock, so moving between setups or trying a different neck tension is a couple-second job.
Dialing in Neck Tension with the .315 Bushing
A good starting point is to measure the neck diameter of a loaded or dummy round that chambers cleanly in your rifle, then subtract about a thousandth to find a sensible bushing dimension. This .315 size is a common landing spot for a number of 7mm loads, but the right bushing always comes down to your specific brass thickness and chamber. Keep in mind the bushing is sold separately from the dies, since the Match Grade system is built around letting you choose the exact size you need.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number: 594315
- UPC: 090255593150
- Inside Diameter: 0.315 in
- Caliber: 7mm
- Type: Neck Sizing Bushing
- Material: Polished Steel
- Design: Self-Centering, Free-Floating
- Compatibility: Hornady Match Grade Full-Length and Neck Sizing Dies
- Quantity: 1 Bushing
- Gun Type: Rifle
- Shipping Weight: 0.025 lb
What’s Included
- One Hornady Match Grade .315 inch neck sizing bushing
Frequently Asked Questions
Does the .315 Match Grade bushing come with a die, or is it sold separately?
This bushing is sold on its own and is not included with the dies. Hornady's Match Grade system is built so you choose the bushing size that matches your brass and chamber, then install it into your Match Grade die.
Which dies does the Hornady Match Grade .315 bushing fit?
It fits both the Hornady Match Grade full-length sizing die and the Match Grade neck sizing die. The full-length die sizes the body, bumps the shoulder, and sizes the neck with the bushing, while the neck die bumps the shoulder and sizes the neck only.
How do I know if .315 is the right bushing size for my load?
Measure the neck diameter of a loaded round that chambers well in your rifle, then subtract about one thousandth of an inch to get a starting dimension. Pick the bushing that lands at or just under that number. The right size depends on your brass thickness and chamber, so .315 may or may not be your match.
Why use a bushing instead of a standard sizing die?
A bushing lets you set the exact neck tension you want rather than sizing down to SAAMI minimum like a standard die. The self-centering design keeps necks concentric and reduces how much you work the brass, which helps case life and consistency on target.



Reviews
There are no reviews yet.