Description
The Hornady Match Grade Bushing in .337 is the small piece that turns a good handload into a great one. It drops into both the Hornady Match Grade full length and neck sizing dies, where its self-centering design keeps everything concentric as you size the case neck. That little detail matters more than you'd think, because a neck that's sized evenly all the way around is a neck that shoots straighter.
What the .337 Match Grade Bushing Does for Your Brass
The whole idea behind a bushing system is control. Instead of over-sizing the neck and springing it back out with an expander ball, you pick a bushing that sizes the neck to exactly the tension you want. The .337 bushing is part of the .30 caliber family, and these fall in the range Hornady spec's for the 308 Winchester and similar 30-cal cases. Sizing only what you need means less working of the brass, which translates to longer case life and more consistent neck tension round after round.
Choosing the Right Hornady Match Bushing Size
Picking a bushing is simple once you know the trick. Measure the neck diameter of a loaded round with a bullet seated, then subtract about a thousandth of an inch. That number gets you close to the right starting bushing, and from there you can fine-tune based on how your rifle likes to shoot. Hornady offers these bushings in tight increments across the 30-cal range, so dialing in the exact tension for your load is doable without a lot of guesswork.
Fit and Build
This is a precision-ground, polished steel bushing built to drop straight into your Match Grade die body with no fuss. Keep in mind the bushing is not included with the dies themselves, so it's sold as a separate component for folks who already run the Hornady Match Grade system or are building one piece by piece. For precision rifle reloaders chasing smaller groups off the bench, it's one of those cheap upgrades that punches well above its price.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number (MPN): 594337
- UPC: 090255593372
- Diameter: .337 inch
- Caliber Family: 30 Cal
- Finish: Polished Steel
- Type: Self-Centering Neck Sizing Bushing
- Compatibility: Hornady Match Grade Full Length and Neck Sizing Dies
- Quantity: 1
- Country of Origin: Made in the USA
What’s Included
- One (1) Hornady Match Grade .337 neck sizing bushing
Frequently Asked Questions
What die does the Hornady Match Grade Bushing .337 fit?
It fits both the Hornady Match Grade full length sizing die and the Match Grade neck sizing die. The bushing is self-centering inside the die body, so it stays concentric while it sizes the neck. Note that the bushing is sold separately and does not come with the dies.
What caliber is the .337 bushing for?
This bushing falls in Hornady's 30-caliber range. The .332, .334, .336 and .338 bushings are listed by Hornady for the 308 Winchester, and the .337 sits right in that family for 30-cal cases. Your exact size depends on your brass and the neck tension you're after.
How do I know which bushing size to pick?
Measure the neck diameter of a loaded round with the bullet seated, then subtract roughly one thousandth of an inch. Choose a bushing at or just under that number as your starting point. From there you can adjust up or down to tune the neck tension your rifle shoots best.
Why use a bushing instead of a standard neck sizing die?
A bushing lets you size the neck to a precise diameter instead of over-sizing and then pulling it back out with an expander. That means less working of the brass, longer case life, and more consistent neck tension from round to round. For precision loads, that consistency often shows up as tighter groups.




Reviews
There are no reviews yet.