Description
When you trim brass or open a bag of fresh cases, the outside of the neck almost always carries a little burr or rough edge. This Hornady Lock-N-Load Large Caliber Deburr tool knocks that down so your case necks chamber clean and your loads stay consistent. It's built for the bigger stuff, covering cartridges from .30 caliber all the way up to .50, which makes it a natural pick for anyone loading heavy hitters that the standard small caliber cutters can't reach.
What the Large Caliber Deburr Tool Handles
The job here is simple but it matters. Deburring the outside of the case mouth removes the slight imperfections that show up on new brass and freshly trimmed cases. Cleaning up that edge helps the round seat and chamber the way it should, and it cuts down on the chance of dragging or hanging up when the case slides into the chamber. You really only need to deburr a case before its first loading and then again anytime you trim it, so this isn't a step you're repeating on every single reload.
Threading It Into Your Hornady Setup
The tool is machined from steel and uses a standard 8-32 thread, which is the same thread Hornady runs across its case prep line. That means it drops right into the Lock-N-Load Case Prep Trio, the Power Case Prep Center, or the Universal Accessory Handle if you'd rather do it by hand. If you already own one of those stations, this is a straightforward add-on that expands your caliber range without buying a whole new setup.
Built the Hornady Way
Hornady has been building reloading gear since 1949, and their case prep tools have a reputation for doing steady work over the long haul. This deburr cutter is made in the USA and designed to keep its edge square to the case mouth, which is exactly what you want when consistency is the whole point. For folks running large rifle brass or specialty big-bore cases, it's an easy piece to keep on the bench.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number: 050171
- UPC: 090255501711
- Type: Outside Diameter (OD) Case Neck Deburr Tool
- Caliber Range: .30 Caliber to .50 Caliber
- Thread: 8-32
- Material: Steel
- Compatibility: Lock-N-Load Case Prep Trio, Power Case Prep Center, Universal Accessory Handle
- Country of Origin: Made in USA
- Shipping Weight: 0.1188 lbs
What’s Included
- Hornady Lock-N-Load Large Caliber Deburr tool (1)
Frequently Asked Questions
What calibers does the Large Caliber Deburr tool work with?
This tool is built for the bigger cartridges, covering everything from .30 caliber up through .50 caliber. It handles the outside deburring on large rifle and big-bore brass that the standard small caliber cutters aren't sized for. If you're loading anything below .30 cal, you'd want the smaller version instead.
Will this deburr tool fit my Hornady case prep station?
Yes. It uses the standard 8-32 thread that runs across Hornady's case prep line, so it threads directly into the Lock-N-Load Case Prep Trio, the Power Case Prep Center, or the Universal Accessory Handle. Any tool station or handle set up for 8-32 threaded cutters will take it.
Does this chamfer the inside of the case too, or just deburr the outside?
This one only handles the outside of the case mouth, knocking down the burr on the exterior edge. For the inside chamfer you'd pair it with the matching large caliber inside chamfer tool. Together they cover both edges of the neck.
How often do I need to deburr my cases?
You really only need to deburr a case before its first loading and then again anytime you trim it back to length. It's not a step you repeat on every reload, so this tool tends to see use during initial case prep and after trimming sessions rather than constant duty.



Reviews
There are no reviews yet.