Description
If you're running a bolt-action 6.5 TCU and want to squeeze every bit of accuracy and case life out of your brass, a dedicated neck sizing die earns its spot on the bench fast. This Hornady Custom Grade Series IV die (part number 046048) works only the neck of the case, leaving the body and shoulder fireformed to your chamber. That means better bullet-to-bore alignment, reduced headspace issues, and brass that lasts noticeably longer than full-length sizing alone.
What the 6.5 TCU Neck Sizer Does on the Press
Neck sizing is the go-to method for folks shooting the same brass back through the same rifle. Because you're not pushing the shoulder back or working the case body, the brass stays snug to your chamber and doesn't get overworked. Keep in mind this is a neck-only die intended for bolt-action and single-shot cases. Semi-autos, lever guns, and pumps generally need full-length sizing to feed reliably.
Inside the Hornady 046048 Die
The internal profile is precision machined and polished to a smooth finish, so cases glide through without sticking or dragging. Hornady's removable elliptical expander is the real standout here, giving you clean, low-friction expansion that cuts down on case neck stretch compared to standard ball expanders. The Sure-Loc lock ring locks your adjustment in place, and the Zip Spindle design keeps the decapping assembly from slipping mid-session. When it's time to clean, the locking retainer spring pops out in seconds for quick disassembly.
Fit and Setup Notes
This die takes a #16 shell holder cap and runs the standard 7/8"-14 thread, so it threads right into any common single-stage press. If you're using a modern Hornady press, you'll want the Lock-N-Load die bushings to make swaps quick. Backed by Hornady's reputation for well-machined gear, this is a straightforward, dependable tool for handloaders who care about consistency.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number: 046048
- UPC: 090255460483
- Caliber: 6.5 TCU (6.5mm Short / .264)
- Die Type: Neck Sizer
- Die Series: Custom Grade Series IV
- Shell Holder Cap: #16
- Thread: 7/8"-14
- Expander: Removable Elliptical Expander
- Lock Ring: Sure-Loc
- Spindle Design: Zip Spindle
- Intended Use: Bolt-action and single-shot rifle cases
What’s Included
- Neck size die
- Sure-Loc lock ring
- Removable elliptical expander
- Decap pin retainer
- Headed decap pins
Frequently Asked Questions
What's the difference between neck sizing and full-length sizing with this 6.5 TCU die?
This die only resizes the case neck, leaving the body and shoulder fireformed to your chamber. That keeps the brass tight to your rifle for better alignment and longer case life. Full-length dies resize the entire case, which is what you'd want for brass used across multiple rifles or in semi-autos, lever guns, and pumps.
Which shell holder does the Hornady 046048 neck sizer die use?
This die uses the #16 shell holder cap. The shell holder isn't included with the die, so you'll want to grab the correct one if you don't already have it on the bench.
Does this Series IV neck sizer die take interchangeable bushings?
No, this is a standard neck sizing die, not a bushing die. It uses a fixed, precision-machined neck profile along with a removable elliptical expander to set neck tension. If you need adjustable neck tension with swappable bushings, you'd be looking at Hornady's Match Grade bushing dies instead.
Will this die work with modern Hornady presses?
Yes, it uses the standard 7/8"-14 thread so it fits common single-stage presses. If you're running a modern Hornady press with the Lock-N-Load system, you'll want the matching die bushings for quick tool-free swaps.




Reviews
There are no reviews yet.