$16.99
56 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Rimfire guns live and die by their extractors, and the little hook on a Ruger bolt takes a beating every time it yanks a spent .22 case out of the chamber. The Tactical Solutions Heavy Duty Extractor is a direct replacement designed to do that job better and longer than the factory piece. The improved hook geometry grabs the rim with more authority, which is exactly what you want when you're running dirty ammo, high volume plinking sessions, or a suppressed setup that gets gunked up fast.
This one is machined from tool steel and then hardened, so it holds its edge and shrugs off the wear and chipping that eventually takes out a stock extractor. That hardening is the whole point here. A worn or rounded hook is one of the most common causes of failures to extract on a 10/22 or a Mark pistol, and swapping in a tougher part is a cheap fix that solves a frustrating problem. It also ships with an extra power spring, so the extractor snaps back into the rim with consistent tension instead of getting lazy over time.
The Tactical Solutions Heavy Duty Extractor drops into the Ruger 10/22 and 10/22 Magnum, and it also fits the Mark I, Mark II, and Mark III pistols along with the 22/45. If you run a TacSol X-Ring rifle built on the 10/22 platform, this is the same part that keeps those bolts cycling clean.
This is a bolt-level job. You'll pull the bolt, drive out the old extractor and spring, and set the new one in its place. Like most replacement extractors, a touch of fitting and deburring around the contact edges helps it ride in and out of the slot smoothly, so take your time and check the fit before you call it done. It's a quick bench project for anyone comfortable detail stripping their rimfire, and it's a solid first upgrade if your gun has started short stroking or leaving brass in the chamber.
Yes. This extractor is made for the Ruger 10/22 and the 10/22 Magnum, and it also works in TacSol X-Ring rifles built on the same platform. It's a direct replacement for the factory extractor on those bolts.
It does. Beyond the 10/22, the Heavy Duty Extractor fits the Ruger Mark I, Mark II, and Mark III pistols as well as the 22/45. That makes it a handy part to keep on the bench if you own more than one Ruger rimfire.
The stock extractor hook can round off or chip over time, which leads to failures to extract and brass left sitting in the chamber. This one is cut from tool steel and hardened, so it holds its edge and bites the case rim more aggressively for the long haul. The included heavier spring also keeps tension consistent.
It's a straightforward bench job if you're comfortable detail stripping your bolt. You remove the old extractor and spring and set the new one in place, and a little deburring around the contact edges helps it slide smoothly in and out of the slot. Most folks can knock it out in a few minutes with basic tools.
| UPC | 879971001978 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | FX01X04 |
| Model |
You must be logged in to post a review.
Reviews
There are no reviews yet.