Frankford Arsenal FX-10 Replacement Tool Head for X-10 Press

Description

Anyone running a progressive press knows the real time sink isn't the loading itself, it's re-setting dies every time you change calibers. This replacement tool head for the Frankford Arsenal FX-10 solves that. Leave a full set of dies mounted and adjusted in each one, then pop the whole plate off and swap to your next cartridge without touching your settings. Buy a head for every caliber you load and your bench turns into a grab-and-go operation.

The head is built from steel for a rigid, no-flex platform and accepts standard 7/8in-14 dies, so whatever you already own or plan to buy will thread right in. It carries all ten stations to match the FX-10's gear-driven shell plate, giving you room for your full workflow including powder check and case trimming dies.

What the FX-10 Tool Head Does on the Bench

The whole point here is repeatability. Once you've spent the time getting a caliber dialed, that work stays locked in on its own tool head. Switching from 9mm to a rifle round like 30-06 becomes a matter of lifting one head off and dropping the next on, instead of breaking down and re-measuring every station. Less fiddling, more rounds downrange.

Lighting and Sensor Ports Built In

This tool head includes an integrated LED to light up your work area, which makes checking powder drops and case mouths a lot easier under a dim bench. It also carries nine 3.5mm micro-USB ports that tie into Frankford Arsenal's Smart Press accessories and sensor-equipped dies, so the head is ready for the electronics side of the FX-10 system, not just the mechanical side.

If you're loading multiple cartridges and want to cut your changeover time way down, keeping a few of these on hand is the way the FX-10 was meant to be run. It's a straightforward upgrade that pays you back every single range trip.