Description
Case prep is where a lot of handloading quality is won or lost, and this Forster 3-in-1 Case Mouth Cutter takes three separate steps and rolls them into one. Built for .224 caliber brass, it mounts on your existing Forster Original or Power Case Trimmer and handles trimming to length, inside chamfer, and outside deburr all at the same time. Fewer steps means fewer chances to introduce inconsistency, and your bench gets a lot less cluttered too.
What the 3-in-1 Cutter Does in One Pass
As the case feeds in, the cutter trims the brass to a uniform length, chamfers the inside of the case mouth to a 14 degree angle, and cuts the outside to a 30 degree angle. That inside 14 degree angle plays nice with both VLD boat tail and standard flat base bullets, so seating goes in smooth without shaving jacket material. Once it is dialed in, you can move through roughly 250 to 400 cases per hour, which is a real time saver on a big batch of .223 or .22 centerfire brass.
Carbide Blades Built to Last
What sets the 3-in-1 Case Mouth Cutter apart is the U.S.-manufactured carbide blade. It holds its edge far longer than standard steel, and when used strictly on brass it should never need sharpening. The blades come factory adjusted on the holder, so you get clean, repeatable cuts right out of the package without a lot of fussing to set it up.
Simple to Install on Your Forster Trimmer
Setup is about as easy as it gets. The cutter slides over the existing cutter shaft on your Forster Original or Power Case Trimmer and locks down with a single set screw. The included .224 pilot is finished in black oxide so you will not mix it up with your standard trimmer pilots. Keep in mind these pilots are caliber-specific, so this one is matched to your .224 brass and is not meant to swap in for other calibers.
Key Specifications
- Caliber: .224
- Function: Trim, inside chamfer, outside deburr
- Inside Chamfer Angle: 14 degrees
- Outside Chamfer Angle: 30 degrees
- Blade Material: U.S.-manufactured carbide
- Trim Rate: 250 to 400 cases per hour
- Compatibility: Forster Original or Power Case Trimmer
- Pilot Finish: Black oxide
- Manufacturer: Forster Products
- Manufacturer Part Number: 3CUT-224
- UPC: 757253996450
- Country of Origin: USA
What’s Included
- One Forster 3-in-1 Case Mouth Cutter (carbide)
- One caliber-specific .224 pilot
- Complete instructions
Frequently Asked Questions
Does the 3-in-1 Case Mouth Cutter work with my trimmer?
It is designed to mount on the Forster Original Case Trimmer and the Forster Power Case Trimmer. It slides over the existing cutter shaft and secures with one set screw. Note that the trimmer itself is not included with this cutter.
Is the .224 pilot included?
Yes. This 3CUT-224 model comes with the caliber-specific .224 pilot in the box. The pilot is finished in black oxide so it is easy to tell apart from your standard trimmer pilots.
Can I use this .224 pilot for other calibers?
No. Forster makes these pilots caliber-specific, and they are not meant to be swapped between calibers. If you reload other calibers you will want the matching 3-in-1 cutter and pilot for each one.
Will the carbide blades need sharpening?
If you run the cutter exclusively on brass cases, the carbide blades should never need sharpening. They are factory adjusted on the holder for clean, consistent cuts and hold their edge far longer than standard steel with proper care.




Reviews
There are no reviews yet.