Description
Fitting a new stock to a Sako is slow, careful work, and the last thing you want is to booger up your good guard screws or crack an expensive blank while checking the fit over and over. That's exactly the job these Forster Stockmaker's Hand Screws were built for. They thread into a Sako action with the correct 6x1mm pitch and give you a set of dedicated screws to run through countless trial fittings while the stock takes shape.
Why These Sako Hand Screws Earn Their Keep
Forster has been making gunsmithing tools since 1935, and these screws carry that same no-nonsense reputation. They're precision made and hardened so they hold up to repeated seating and removal without wearing or galling. Leading stockmakers reach for tools like this during final inletting because they keep the trigger guard and action lined up properly with the stock, which is the difference between a tight, professional inlet and a sloppy gap you'll be staring at forever.
Getting the Most From Your Stockmaker's Hand Screws
Use them anytime you need to pull the barreled action in and out during fitting. Because you're not cranking your finished guard screws in and out a hundred times, you avoid the buggered slots and stripped threads that come from using the real hardware as fitting tools. Snug the action, check your contact points, scrape or sand, and repeat. When the inlet is dialed in, swap in your permanent screws and you're done.
This set fits Sako actions except the Model 75, and comes as a pair. If you're bedding, restocking, or building out a Sako project, these belong in the drawer next to your inletting black and scrapers.
Key Specifications
- Manufacturer: Forster Products
- Manufacturer Part Number: SMSAKO
- Model: Sako
- UPC: 757253006111
- Fits: Sako actions (except Model 75)
- Thread: 6x1mm
- Quantity: Set of 2
- Material: Hardened steel
- Use: Stock inletting and final fitting
What’s Included
- 2 stockmaker's hand screws (6x1mm thread, fits Sako)
Frequently Asked Questions
What are these Sako stockmaker's hand screws used for?
They're dedicated guide screws for fitting and inletting a stock to your Sako action. You thread them in to hold the barreled action in alignment while you check and refine the fit, then remove and reinstall as many times as needed. When the inlet is finished, you swap in your permanent guard screws.
Will these fit any Sako rifle?
This set uses a 6x1mm thread and fits Sako actions except the Model 75. If you're not sure which action you have, check your existing guard screw thread pitch before ordering so you get the right match.
How many screws come in the set?
You get two screws per set, which is what you need to hold the front and rear of the barreled action while inletting. Forster designed them to be used as a pair for proper alignment.
Why not just use my regular guard screws for fitting?
Running your finished guard screws in and out during trial fitting is a fast way to bugger the slots or strip the threads, and it can slow the whole job down. These hardened hand screws take that abuse instead, saving your real hardware and your stock blank. They're built to handle repeated trial fittings without wearing out.





Reviews
There are no reviews yet.