Description
Small Glocks like the 26 and 27 are fantastic for carry, but that stubby little grip leaves a lot of hands hanging in the air with nowhere to put a pinky. The Pearce PG-26XL fixes that. This grip extension swaps out your factory magazine base plate and adds roughly a full inch of length, so you finally get a full, three-finger hold on the gun. Better control, better comfort, and none of the wobble you get from letting that bottom finger dangle.
What the PG-26XL Does for Your Sub-Compact Glock
This one is built specifically for the Gen 3 Glock 26, 27, 33, and 39. It replaces the mag base plate and keeps every other factory component in place, and it does not change your round count at all. So you keep the same magazine capacity you already carry, you just get a longer, more usable grip. Folks with medium to large hands tend to notice the difference immediately, and it makes drawing the pistol a whole lot smoother, especially out of soft or minimal holsters where the little nub grip can be tough to get a solid purchase on.
Fit and Feel of the Pearce Grip Extension
Pearce molds these from high impact polymer that shrugs off drop testing across a wide temperature range, so it holds up to real carry and range use. It's textured and contoured to match the frame, giving the gun a clean, factory look rather than a bolt-on aftermarket vibe. There's also a Mag-Track feature molded in, which is handy if you rotate several magazines and want a way to keep track of them.
One tip from folks who run these: if the fit feels stiff going on, a quick dip in hot water for a minute or two softens the polymer just enough to slide it into place and line it up right. Once it's seated it locks in tight and stays put. If you're running Gen 4 or Gen 5 magazines in a Gen 3 frame, Pearce makes a matching version for those mags, so check your magazine generation before ordering.
Key Specifications
- Manufacturer: Pearce Grips
- Manufacturer Part Number: PG-26XL
- UPC: 605849200330
- Model Fit: Glock 26, 27, 33, 39 (Gen 3)
- Product Type: Grip Extension / Magazine Base Plate
- Added Length: Approximately 1 inch
- Capacity Change: None
- Material: High Impact Polymer
- Color: Black
- Finish: Textured
- Special Feature: Mag-Track magazine identification
- Temperature Rating: -20 F to 250 F drop tested
What’s Included
- One Pearce PG-26XL grip extension
Frequently Asked Questions
Does the Pearce PG-26XL add any rounds to my Glock magazine?
No, this extension does not change your magazine capacity at all. It replaces the factory base plate and gives you about an inch of extra grip length while retaining the same round count. The benefit here is control and comfort, not extra ammo.
Will this Pearce grip extension fit my Glock 26, 27, 33, or 39?
Yes, the PG-26XL is designed for the Gen 3 Glock 26, 27, 33, and 39. If you're running Gen 4 or Gen 5 magazines in a Gen 3 frame, Pearce recommends the matching Gen 4/5 version instead. Check the generation of your actual magazines before ordering.
Is the PG-26XL hard to install?
Installation is straightforward and requires no gunsmith. You slide off the factory base plate and slide the Pearce extension into place. If it feels tight, dipping it in hot water for a minute or two softens the polymer and makes it easier to seat and align.
How much does the Pearce grip extension add to the grip?
It adds roughly one full inch of length to the bottom of the grip. That's enough to give most shooters a solid spot for their pinky finger and a full three-finger hold. It also helps the pistol ride higher and draw cleaner out of soft holsters.




Reviews
There are no reviews yet.