$35.97
71 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Firefield Edge FF34053 is a carbine-length, two-piece KeyMod handguard built to replace the flimsy A2-style plastic furniture that comes standard on a lot of AR-15 carbines. It measures 6-5/8 inches long and is machined from 6061-T6 aircraft-grade aluminum with a hard-anodized matte black finish, so you get a rigid, corrosion-resistant platform that stands up to hard use and weather without adding much bulk. The aggressive, precision-cut profile looks sharp on a build and gives your support hand plenty to grab onto.
This is a drop-in rail, which is the no-gunsmith route. The two halves seat under your rifle's existing delta ring at the rear and into the handguard cap behind the front sight base up front. Pull the delta ring back, line up both halves, and let it snap into place. Most folks can knock this out on the kitchen table with the included hex key and no barrel nut wrench or vise required. A delta ring tool makes the job even quicker if you swap furniture often, but it isn't a must.
KeyMod slots let you add rail sections exactly where you want them, so you can hang a light, foregrip, sling mount, or laser without cluttering up the whole handguard. The rail is Picatinny, Weaver, and NATO compatible once you attach the included accessory section, which keeps you open to just about any AR accessory on the market. Because it fits carbine-length gas systems specifically, make sure your rifle runs a carbine-length setup with a standard front sight base or gas block before ordering.
At roughly 5.9 ounces, the Edge keeps your rifle nimble and quick to point. It protects the barrel from handling and the elements while giving you a modern mounting surface that plain factory handguards just can't match. For anyone looking to modernize a stock carbine on a budget without pulling the barrel, this is a smart, straightforward pick.
It's designed for carbine-length AR-15 rifles that still use a standard delta ring and handguard cap, which covers most stock carbines. The rear seats under the delta ring and the front sits in the handguard cap behind your front sight base or gas block. If your rifle already has a free-float handguard with no delta ring, this drop-in rail won't work, so check that first.
No. This is a true drop-in rail, so you just pull the delta ring back, line up both halves, and seat it using the included hex key. A delta ring or handguard removal tool makes it faster and easier on the fingers, but you don't need a barrel nut wrench, vise, or a trip to the shop.
It uses KeyMod slots so you can bolt on rail sections wherever you want them, then hang lights, foregrips, sling mounts, and lasers. With the included accessory rail piece attached, it's compatible with Picatinny, Weaver, and NATO mounts, so most common AR-15 accessories will work fine.
No, the Edge is a drop-in style that makes contact with the barrel through the delta ring and cap rather than floating off the upper receiver. That trade-off is what makes it so simple to install without pulling the barrel. If you want maximum accuracy potential and don't mind a more involved install, a free-float model is the way to go, but for a quick, tough upgrade this one is hard to beat.
| UPC | 812495023781 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | FF34053 |
| Product Type | KeyMod Mount |
You must be logged in to post a review.
Reviews
There are no reviews yet.