$11.99
34 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The extractor spring is one of those tiny parts that can make or break how a rifle runs, and BCM builds this one to solve the exact problems that trip up factory bolts. Stock springs tend to soften over time, which is when you start seeing failure-to-extract or double feed headaches. This kit swaps in a heavy coil spring built for the extra tension short barreled AR-15, M4, and M16 builds demand, and it firms up ejection on standard 16 inch and 14.5 inch carbines too.
BCM starts with high quality chrome silicon, heat treats it to relieve stress, then shot peens the spring to add strength where it counts. That combination is why folks say the spring feels noticeably stronger the moment they compare it to a worn factory unit. Each set also ships with the newer black extractor insert, the same one that comes standard on M4, M4A1, and Mk18 carbines, plus a Mil-Spec Crane O-ring for anyone who wants that extra bump in tension.
The fix here is simple but effective. If your brass is landing at the wrong clock position or you are chasing the occasional failure to eject, the added spring pressure keeps the extractor claw biting into the case rim through the full cycle. You can run the spring and insert alone, or add the O-ring if you want maximum grip, which gives you room to tune the setup to your particular bolt and load.
Buying the 3 pack means you can freshen up several bolt carrier groups at once or stash spares in your grip and range bag for down the road. It is cheap insurance for a part that takes a beating every single round, and having backups on hand beats scrambling when a spring finally gives out. Quick to install with basic bolt disassembly, it is one of the easiest upgrades you can make to keep an AR running the way it should.
It is aimed squarely at failure-to-extract and inconsistent ejection, which usually show up as brass flying out at the wrong angle or the occasional stuck case. The heavier coil spring keeps steady tension on the extractor claw so it holds the case rim through the entire cycle. Many folks report going from occasional failures per magazine to clean, consistent ejection after the swap.
Not always. BCM's spring is strong enough that the Mil-Spec Crane O-ring often is not needed, but it is included so you can add extra tension if your particular bolt or ammo calls for it. Think of it as a tuning option rather than a required part.
It works across the board. The kit was designed for the increased extractor tension that short barreled AR-15, M4, and M16 setups need, but it also improves reliability on standard 14.5 inch and 16 inch carbines. As long as you are running a standard AR-15 style bolt, it drops right in.
The 3 pack lets you upgrade multiple bolt carrier groups at once or keep spares on hand for future maintenance. Since the extractor spring is a wear item that works hard on every round, having backups tucked in your grip or range bag is smart insurance.
| UPC | 812526020635 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BCM-EXSPRING-3 |
You must be logged in to post a review.
Reviews
There are no reviews yet.