$12.83
50 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The factory extractor in a Ruger 10/22 is a stamped piece of sheet metal, and it works fine right up until it doesn't. Volquartsen builds the Exact Edge Extractor to fix that weak link before it costs you a range trip. Rather than stamped steel or titanium that rolls over and starts causing extraction problems after some use, this one is cut from A2 tool steel and hardened to a Rockwell of Rc 58 to 60 so the hook keeps its bite for years.
Volquartsen machines this part using an EDM (electrical discharge machining) process, which lets them hold tolerances down to plus or minus .0001 inch. The hook itself sits about .005 inch closer to the rim of the cartridge than the factory piece, and that small change is what gives you cleaner, more positive extraction on spent cases. There's also a beveled edge machined into the bottom of the extractor to keep it from catching on the next round feeding up out of the magazine, which smooths out the whole cycle.
This is the VC10EE, built for the Ruger 10/22 and 10/22 Magnum, and it also drops into the Ruger Charger along with the Mark series pistols and 22/45 variants. Owners who've fought failures to extract, stovepipes, and general jamming across different ammo brands often point to this as one of the first upgrades worth making. Shooters running mixed bulk ammo report clean cycling once the new extractor is in.
Swapping it in is a job most folks can handle at the bench. You pull the bolt, release tension on the extractor plunger, slide the old part out, and drop the new one in the same notch before easing the plunger back. A pick and a clean, non-slip surface make it painless. No gunsmithing, no permanent changes, and you can put your factory part back in the parts drawer if you ever want it.
Yes, the VC10EE is made for both the standard Ruger 10/22 and the 10/22 Magnum. It also fits the Ruger Charger as well as the Mark series pistols and 22/45 variants, so it covers a wide range of Ruger rimfire platforms.
Most owners install it themselves at home with basic tools. You remove the bolt, release the extractor plunger tension, slide the old extractor out, and drop the new one into the same notch. A small pick and a clean, non-slip surface make the swap quick and reversible.
The factory extractor is stamped sheet metal that can wear and cause extraction issues over time. This one is EDM-machined from A2 tool steel and hardened to Rc 58-60, with the hook positioned about .005 inch closer to the cartridge rim for a more positive grip on the case. That combination helps clear up failures to extract and stovepipes.
The VC10EE is the extractor itself and is designed to run with your existing factory spring and plunger. If you want a spring upgrade too, Volquartsen offers it separately or as part of a bolt tune-up kit that also includes their SureStrike firing pin.
| UPC | 810162010546 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | VC10EE |
| Model |
You must be logged in to post a review.
Reviews
There are no reviews yet.