$35.99
3 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you run a Browning A-Bolt 12 gauge slug gun and want a dependable platform to hang glass on, this EGW Picatinny rail is about as straightforward as it gets. It bolts right to your receiver's factory scope holes, so there's no drilling or tapping involved. EGW machines these in-house from domestic 6061-T6 extruded aluminum, then tumbles, sandblasts, and Type II anodizes them in a matte black finish that holds up to the recoil a 12 gauge dishes out.
This is a one-piece design with Picatinny cross slots running the full length of the rail. That gives you real flexibility to slide your rings fore and aft and dial in eye relief exactly where you want it. It accepts any standard Picatinny or Weaver rings, so you're not locked into a single ring brand. A milled center channel trims the overall weight down to about 2 ounces, and in a lot of setups that channel leaves your factory iron sights usable underneath.
The 0 MOA setup is the one you want for shorter range work, generally inside 500 yards, which covers just about any slug gun application. It keeps your scope's adjustment range centered so you've got plenty of travel both ways when zeroing. The ambidextrous bevel on both sides means it looks clean and works the same whether you're a lefty or a righty.
Overall length runs 7.064 inches with a center spread of 3.86 inches between the two middle receiver holes. It's a good idea to measure your receiver's hole spacing against those numbers before ordering to confirm the fit. Mounting hardware comes in the box, and EGW recommends torquing the screws to 20 inch pounds with a drop of blue Loctite for a mount that stays put shot after shot.
No. It's drilled to line up with the factory scope mount holes on your A-Bolt 12 gauge receiver, so it bolts right on. EGW recommends measuring your receiver's hole spacing against the 3.86 inch center spread to confirm the fit before installing.
It accepts any standard Picatinny or Weaver scope rings since the cross slots run the full length of the rail. That gives you flexibility to position rings and fine-tune eye relief. Rings are not included, so plan to pick up a set that matches your scope tube diameter.
A 0 MOA rail sits flat with no built-in forward angle, which is ideal for close to mid range shooting out to around 500 yards. That covers just about any slug gun setup. It keeps your scope's elevation adjustment centered with plenty of travel in both directions.
The milled center channel that reduces weight also leaves the iron sights usable in many setups. Fit can vary depending on your specific sights and scope ring height, so it's worth checking your particular configuration once installed.
| UPC | 841370106080 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 43200 |
| Color | Black |
| Model | |
| Style | Picatinny Rail |
You must be logged in to post a review.
Reviews
There are no reviews yet.