$179.95
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Threading a hot suppressor on and off gets old fast, and carbon lock on a direct-thread can is nobody's idea of a good time. The Breek-LOK 3QD HUB from Breek Arms fixes both problems. It threads into any suppressor with the industry-standard 1.375×24 HUB pattern and converts it into a quick-detach can that mounts to Breek's 3QD muzzle devices with a simple push, a 60 degree twist, and a final half turn to seat the taper. No tools, no shims, no timing headaches. When you want the can off, reverse the motion and it's in your hand in seconds.
Breek machined this hub from aerospace-grade titanium, and it shows on the scale. At 2.3 ounces, it's noticeably lighter than a lot of the popular HUB mounts out there, which matters when you're already hanging a can off the end of your barrel. The DLC finish adds a hard, slick outer layer that shrugs off wear and heat, and the whole assembly only stretches your suppressor by 1.15 inches, so it keeps a clean, low-profile look on the gun.
The magic here is the dual engagement design. Tri-lug geometry handles the fast attachment, while an internal tapered seat pulls everything tight against the matching taper on the muzzle device. That taper is what gives you repeatable alignment, so the suppressor goes back to the same spot every time you reinstall it. The system is rated for calibers up to .308 Winchester, which covers everything from 9mm PCCs to 5.56 carbines to short-action bolt guns.
Installation is straightforward: the hub uses a 37mm hex to torque into your suppressor, and then it stays put. Grab a Breek-LOK 3QD muzzle device for each host rifle and you can swap one can across your whole safe. Keep in mind the muzzle devices are sold separately, so plan your setup accordingly. For anyone running a HUB can on multiple guns, this is one of the lightest ways to make that painless.
It threads into any suppressor built on the industry-standard 1.375×24 HUB pattern, which covers a huge chunk of modern cans from a wide range of manufacturers. If your suppressor takes HUB mounts, this will screw right in. It installs with a 37mm hex, so torquing it in place is quick work.
No, this listing is for the HUB mount assembly only. The system locks onto Breek Arms 3QD tri-lug muzzle devices, which are sold separately. Most folks pick up one muzzle device per host rifle so they can move a single can between guns in seconds.
The system is rated for calibers up to .308 Winchester. That gives you a lot of room to work with, from 9mm carbines and 5.56 rifles up to short-action hunting and precision setups, as long as your suppressor itself is rated for the cartridge you're running.
The 3QD uses two engagement points working together: tri-lug geometry for the fast on-and-off, plus an internal taper that seats against a matching taper on the muzzle device. You push the hub on, rotate it 60 degrees, then finish with a half turn to snug the taper. That tapered seat is what keeps things locked under fire and brings the can back to the same position on reinstall.
| UPC | 812296031718 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BRK4300 |
| Color | Black |
| Model | |
| Shipping Weight | 0.408 |
You must be logged in to post a review.
Reviews
There are no reviews yet.