$225.00
15 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
A hot can will ruin your day fast. Whether it is a scorched sling, melted pack straps, or a burned hand during a barricade drill, suppressor heat finds a way to bite you. The Burn Proof Gear Suppressor Cover Heavy exists to stop that, and it does the job better than just about anything else out there. This 7.5 x 1.5 version is sized for 1.5 inch diameter cans, and the cover runs a half inch long on purpose so it can cinch down around the front and rear of the suppressor. That is the no-slip fit Burn Proof Gear is known for, and it means the cover stays put through rapid strings instead of walking forward like cheaper wraps tend to do.
The Heavy cover is a two-part system. The outer shell is DuPont Kevlar rated to 1000 degrees Fahrenheit, which works out to roughly 180 rounds of M855 fired hard. Underneath sits a fiberglass mesh sleeving liner rated to a full 2000 degrees. Because the liner is replaceable, you can swap it out down the road instead of buying a whole new cover, which stretches the life of the whole setup considerably. It works with suppressors across the common calibers, including .223, 5.56 NATO, 300 BLK, .308, and 7.62 NATO, and it is full auto capable.
Beyond keeping skin and gear off hot metal, this cover kills heat mirage over the can, which matters a lot if you are shooting precision and watching your sight picture shimmer after a few rounds. It also cuts down the IR signature a hot suppressor throws off at night. Installed, it only adds about a quarter inch to the diameter, so a wrapped can stays under 1.75 inches and remains slim enough for most handguards and bags. It is made in the USA, combat proven, and covered by a lifetime guarantee. Just measure your suppressor before ordering, since the Heavy line is built specifically around 1.5 inch diameter cans and the right length makes all the difference in getting that snug fit.
The Heavy cover is built specifically for suppressors that are 1.5 inches in diameter, so measure your can before ordering. It will not properly fit larger diameter suppressors, even ones that are close like 1.56 inches. For length, Burn Proof Gear designs their covers to cinch at the front and rear, so checking their fit guide against your exact suppressor model is the best way to nail the size.
The outer DuPont Kevlar shell is rated to 1000 degrees Fahrenheit, which is roughly 180 rounds of M855 fired at a hard pace. The inner fiberglass mesh liner is rated to 2000 degrees, and the cover as a whole is full auto capable. That said, no cover is invincible, so give your can breaks during extended high volume shooting.
No, that is the big selling point of the Burn Proof Gear design. The cover is made a half inch longer than the suppressor so it cinches down around both the front and rear, and the mesh liner grips the can body. Burn Proof Gear backs it with their no-slip fit guarantee, and it holds position even under sustained fire.
Yes. The Heavy cover is a two-part system with a Kevlar outer cover and a separate fiberglass mesh inner sleeving. If the liner takes a beating over time, you can swap in fresh sleeving and keep running the same cover, which extends the life of the product significantly.
| UPC | 644042980601 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BPG-SC-H-7-5-1-5-BLK |
| Product Type | Cover |
| Color | Black |
| Model |
You must be logged in to post a review.
Reviews
There are no reviews yet.