Hoppe’s BoreSnake Den .35-.375 Cal Rifle Bore Cleaner with Case

Description

The Hoppe's BoreSnake Den takes the tool that made rod-and-patch cleaning feel like a chore and pairs it with a case that actually makes sense. Drop the brass weight through your barrel, grab the handle, and pull. The integrated bronze brush scrubs out carbon fouling on the way through while the long braided tail wipes the bore clean, all in one pass. That tail carries roughly 160 times the surface area of a standard patch, so you're covering a lot of ground fast. This one is sized for .35 through .375 caliber rifles, and the brass weight is stamped with the size so you can grab the right snake at a glance.

What the Den Case Adds to the BoreSnake

The part that sets this apart from a bare BoreSnake is the storage. The clear snap-on case keeps the snake coiled, contained, and free of grit between cleanings, which matters more than folks expect. A BoreSnake that's been rattling loose in a range bag picks up dirt and debris, and you don't want to drag that back through your barrel. The lid clicks off and turns into a pull handle, so you skip the old routine of winding cord around your hand to get enough grip.

Keeping Your BoreSnake Den in Good Shape

A BoreSnake is built to be reused for a long time. Most folks give it a quick wipe after each use and toss it in the wash once it starts looking grimy. Warm water with a little dish soap works fine, and plenty of people run it through the machine inside a sock or mesh bag so it doesn't tangle. The one rule worth following: let it dry fully before it goes back down a barrel, since a damp snake defeats the purpose. Do that and this thing will outlast a whole shelf of patches.

For best results, add a few drops of your favorite solvent to the bristle section before your first pass, then finish with a light pass of oil to leave a protective coat. It's a genuinely fast way to keep a hunting rifle or range gun running clean without breaking out the full cleaning setup.