Lapua 7mm PRC Unprimed Brass Cases 100 Count 4PH7099C

Description

The wait for premium 7mm PRC brass is over. These are genuine Lapua cartridge cases carrying the 4PH7099C part number, sold under the Berger label since both brands live under the same Capstone/Nammo roof. If you shoot the 7 PRC and reload, this is the component that competitive long-range folks and serious hunters have been holding out for.

The 7mm PRC was designed from the ground up with accurate chamber geometry, an efficient case shape, and the right overall length to feed today's long, low-drag .284 bullets without cramming them deep into the powder column. It runs a large rifle primer pocket and thrives on slow-burning powders, which is exactly where the heavier 175-plus grain projectiles come alive with strong retained energy and consistent velocities. It fits a standard long action too, so you get magnum-class ballistics without needing an oversized receiver.

What Sets This Lapua 7mm PRC Brass Apart

Lapua draws the case heads exceptionally hard, so the primer pockets stay tight through many firings and the body resists stretching. The base, body, and neck are held to strict tolerances that stay put across repeated reloading cycles, and the neck and shoulder come annealed to take the beating that resizing dishes out. Reloaders who have run Lapua before know the flash holes come clean and the wall thickness is consistent, which cuts down on prep work at the bench.

Getting the Most From Your 7 PRC Handloads

Every piece is new, unprimed brass ready for your load development. Most handloaders will still run each case through a sizing die to set uniform neck tension and true up any necks that shifted during shipping, but the tolerances are tight enough that you're doing very little cleanup before that first firing. Pair it with a quality large rifle primer, a temperature-stable powder, and your bullet of choice, and you've got the makings of a load that prints tight groups and stretches out to distance with confidence.