$105.15
21 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Ask anyone who has worn out a mil-spec charging handle and they will tell you the failure points are always the same: the roll pins and the pivoting latch. Battle Arms Development threw both of those out the window with the RACK. Instead of a latch that pivots and beats up the notch in your upper, the RACK uses a patented latch that slides parallel to the receiver notch. The result is a quicker release, less wear over the long haul, and that glassy smooth feel every time you rack it.
This thing is refreshingly simple, built around just three major components with the handle itself machined from a single piece of 7075-T6 billet aluminum. That monolithic design is a big part of why it feels so solid in the hand and stays balanced when you pull it. It also skips the roll pins entirely, which knocks out one of the most common weak spots on a standard AR charging handle. The finish is a proper hard-anodized black coat that shrugs off wear and corrosion and blends right into any dark AR build.
Everybody has their own way of charging a rifle, and the RACK was designed with that in mind. The asymmetric mechanism keeps the handle from twisting under side-load pressure, so a pull from the left feels just as smooth and positive as a pull from the right. No flimsy torque, no wobble. Whether you are a lefty, a righty, or somebody who runs a support-hand rack, it gives you consistent operation from either side.
Because the RACK makes no contact with the sides of your receiver, it keeps wear off both the handle and the upper, which matters if you shoot a lot. At right around 1.48 ounces it stays light without giving up strength, and it drops right into standard mil-spec-sized AR uppers. It is designed and CNC machined in the USA and works across AR-15, AR-10, and 9mm AR PCC platforms, so it is a solid upgrade whether you are building fresh or replacing a tired factory handle.
Yes, the RACK drops into standard mil-spec-sized AR upper receivers as a direct replacement for your factory charging handle. It is a simple swap that requires no gunsmithing. The same handle is also listed as compatible with AR-10 and 9mm AR PCC uppers that use mil-spec charging handle dimensions.
The big difference is the mechanism. Instead of roll pins and a pivoting latch that wear out the notch in your upper, the RACK uses a patented latch that slides parallel to the receiver notch. It also makes no contact with the sides of the receiver, which cuts down wear on both the handle and your upper over thousands of cycles.
It is. The asymmetric design keeps the handle from twisting under side-load pressure, so a left-hand pull feels just as smooth and positive as a right-hand pull. However you rack your rifle, whether by habit or training, it gives you consistent operation from either side.
No, the RACK is strictly a charging handle and does not interfere with separating your upper and lower receivers. It installs and removes just like a standard charging handle. You take it in and out the normal way through the back of the upper.
| UPC | 810033781834 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BAD-RACK-15 |
| Color | Black |
| Length | 7.3500 |
| Model | |
| Product Type | Charging Handle |
You must be logged in to post a review.
Reviews
There are no reviews yet.