$15.99
15 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Every AR build eventually gets that itch to add a little character, and the ejection port cover is one of the easiest spots to do it. Battle Arms Development took a plain, hardworking part and dressed it up with the classic 'Smile Wait for the Flash' engraving, cut cleanly into the inside face of the cover. When the port pops open during firing, that art is right there facing the world. Finished in matte black to blend with just about any AR-15, it does the same job as any factory cover while giving your rig some flavor.
Underneath the engraving, this is a fully functional ejection port cover. It snaps shut to keep dust, sand, lint, and grit out of your upper receiver and off your bolt carrier group, which is exactly the kind of gunk that leads to feeding hiccups down the range. When the bolt cycles, the cover springs open and stays out of the way. So you get real protection for your internals plus a conversation piece, all in one small part.
This is a direct-fit part for standard AR-15 and M16 pattern upper receivers. It measures roughly 3.15 inches long and 4.15 inches wide with a low 0.60-inch profile, matching the mil-spec footprint most uppers are cut for. One thing worth flagging up front: this cover ships on its own with no hardware. The spring, ejection port rod, and C-clip are not included, so if you're building from bare or your old set is worn, plan on grabbing that hardware separately.
Swapping a dust cover is a solid entry-level project and a fun one. You'll want a roll pin punch, a small hammer, and a clean flat workspace, and a little magnet nearby makes wrangling the C-clip a lot less frustrating. The trickiest part is getting the spring oriented so the cover holds tension in the closed position, but take your time and work it a couple of times once it's seated. Building a rifle or swapping barrels is the perfect moment to drop this one in.
No, this cover ships by itself with no hardware. The spring, ejection port rod, and C-clip are not included. If you're building from scratch or your existing hardware is worn out, grab a small parts kit to go along with it.
Yes, it's a direct-fit part for standard AR-15 and M16 pattern upper receivers cut to the usual mil-spec dimensions. It measures about 3.15 inches long by 4.15 inches wide. As long as your upper takes a standard cover, this one drops right in.
The 'Smile Wait for the Flash' art is laser engraved on the inside face of the cover. That means it faces outward and shows off when the port is open during firing. When the cover is closed, you get a clean matte black exterior.
It's a beginner-friendly project and a great first mod. You'll need a roll pin punch, a small hammer, and a flat clean surface. The spring orientation is the fiddly part, so take your time getting the tension right, and a small magnet helps keep the C-clip from wandering off.
| UPC | 810033782350 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BA-LS-DC-Smile Wait for Flash |
| Length | 3.1500 |
| Color | Black |
| Product Type | Dust Cover |
You must be logged in to post a review.
Reviews
There are no reviews yet.