$39.99
3 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The AimShot KT6506-P238 is a red laser made to fit the SIG P238 and P938 without turning your slim single-stack into a bulky handful. Instead of clamping onto a rail these little pocket guns don't have, it mounts to the trigger guard and hugs the frame, keeping the pistol pocket and holster friendly. It runs a 650nM red beam at under 5mW, which is plenty for the close-range distances a gun like the P238 is built for.
The housing is nylon reinforced with carbon fiber, so it stays light and tough while adding around 1.2 ounces to the pistol. Activation is ambidextrous with buttons on both sides, so lefties and righties both get an easy reach. There's a 5 minute auto shut-off built in, which helps save the battery if the laser gets bumped on in a pocket or bag. It's also water resistant, which is a nice touch for an everyday carry setup.
Windage and elevation both adjust with the included wrench, so you can walk the dot to your point of impact without any guesswork. Mounting is a simple two-screw job on the trigger guard, and most folks have it on and sighted in during one range trip. Once it's zeroed, the low-profile design tends to hold up through regular shooting.
Power comes from a single CR1/3N battery, which is included, and you also have the option to run two LR44 cells instead. You'll get a little over two hours of continuous runtime, which stretches a long way in real use since the laser is only on when you need it. For anyone carrying a P238 or P938 and wanting a fast aiming reference in low light or high-stress moments, this is a compact, no-frills way to get there.
Yes. This AimShot laser is custom fit for the SIG Sauer P238 and P938, since the two share the same frame geometry at the trigger guard. It's designed specifically for those models rather than a universal fit, which is why the mounting lines up cleanly.
It attaches to the trigger guard using two screws, so there's no rail required. That trigger guard placement is what lets it work on slim carry guns like the P238 that don't have an accessory rail. Most people find the install quick and have it on in a few minutes.
It runs on a single CR1/3N battery, which is included in the box, or you can swap to two LR44 cells. You'll get over two hours of continuous runtime, and the 5 minute auto shut-off helps preserve that battery if the laser gets activated by accident.
Yes. Both windage and elevation adjust using the included wrench, so you can zero the dot to where your rounds are actually landing. Plan to sight it in at the range after mounting to get it dialed in for your load.
| UPC | 669256650652 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | KT6506P238 |
You must be logged in to post a review.
Reviews
There are no reviews yet.