Description
If you burn through 9mm and want to take your bullet supply into your own hands, the Lee Precision 90402 is built to keep the lead flowing. This 6-cavity block produces a .356 diameter, 124 grain truncated cone bullet that works great for 9mm Luger, 38 Super Auto, and 380 Auto. The truncated cone profile feeds well in most semi-autos and gives you a clean, consistent bullet you can load and go with once you dial in your process.
The mold blocks are machined from commercial-grade aluminum, which is the real advantage here. Aluminum heats up and cools down faster than iron or steel, so you can usually get good bullets after just a few casts, and the lighter weight means less hand fatigue during a long session at the pot. Each block is CNC machined for roundness and size control, and the halves ride on steel bushings and alignment pins so your cavities line up shot after shot. The hard-anodized sprue plate is cam operated and held tight by tempered spring washers on each end.
Getting the Most Out of the 90402 6-Cavity Mold
Like any six-banger, this mold rewards a little patience up front. Pre-heating the blocks and sprue plate before you start pouring is the trick that separates frustration from frosty, well-filled bullets. A lot of casters bring the mold up to temp on the edge of the pot, then start with a couple of cavities and work up to all six as the block evens out. Cast hot, move at a steady pace, and you can produce bullets in serious volume.
A Note on Handles for the 9mm Truncated Cone Mold
This is the no-handles version, so you'll need a set of Lee 6-cavity mold handles to run it. They are sold separately and are worth grabbing at the same time if you don't already own a compatible pair. Pick up a sizing die in .356 if your particular barrel prefers a sized bullet, though plenty of folks find the as-cast bullet drops right where they want it.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90402
- UPC: 734307904029
- Caliber: 9mm Luger / 38 Super / 380 Auto
- Bullet Diameter: .356"
- Bullet Weight: 124 Grain
- Bullet Profile: Truncated Cone (TC)
- Number of Cavities: 6
- Block Material: Aluminum
- Sprue Plate: Hard-anodized, cam operated
- Handles: Sold separately
What’s Included
- Lee Precision 6-cavity bullet mold block (9mm 124gr TC)
Frequently Asked Questions
Does the Lee 90402 6-cavity mold come with handles?
No, this is the no-handles version. You'll need a set of Lee 6-cavity mold handles to run it, and they are sold separately. If you already own a Lee 6-cavity handle set, it will fit this block.
What calibers can I use bullets from this 9mm truncated cone mold for?
The mold drops a .356 diameter 124 grain truncated cone bullet suited for 9mm Luger, 38 Super Auto, and 380 Auto. The truncated cone profile tends to feed reliably in most semi-autos. Always confirm the as-dropped diameter works with your specific barrel.
Do I need to size the bullets from the 90402 mold?
It depends on your firearm. Many casters find the bullets drop close to .356 and load up fine as cast, while some barrels shoot better with a sized bullet. Measuring a few dropped bullets and running a plunk test in your barrel will tell you whether you need a .356 sizing die.
Any tips for casting well with this 6-cavity block?
Pre-heat the blocks and sprue plate before you start, since a cold six-cavity mold won't fill cleanly. Many casters bring it up to temp on the edge of the pot, then begin with a couple of cavities and work up to all six as the block evens out. Cast hot and keep a steady rhythm for the best results and high output.




Reviews
There are no reviews yet.