$125.99
3 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
This is the starting point for anyone chasing a perfectly matched seating die for a 7mm chambering that nobody makes an off-the-shelf die for. The L.E. Wilson 7mm Stainless Micrometer Top Seater Die Blank is a partially machined stainless body with the bore hole already finished and a pilot hole drilled through, intentionally left long so it can be trimmed to final length once the chamber is cut. Hand it off to a competent gunsmith, have them run your chamber reamer in, and you end up with an in-line seater dialed to your exact brass.
The Wilson chamber-type design is what precision reloaders reach for when concentricity matters. Instead of relying on sliding collars like a conventional threaded die, the case and bullet are fully captured inside the die body, and the bullet gets pushed straight down into the neck by a close-fitting seating stem. The case stays stationary while the bullet moves, which keeps runout about as low as it gets and is a big reason these dies have such a strong reputation for accuracy.
The built-in micrometer top reads in .001 inch graduations, so setting and repeating your seating depth is quick and foolproof. Note down your number, make the move, and you are back on your load without guesswork. That kind of fine control is exactly what you want during load development when you are testing seating depth against the lands in small steps.
This is a hand-die setup meant for an arbor press, and it can even be run with a soft-faced mallet in a pinch. It is not designed to thread into a conventional reloading press. Place your charged, primed case and bullet into the body, set it on the base, and press the cap until it bottoms out. L.E. Wilson has been building precision reloading tools in the USA for decades, and a chamber reamed off one of their blanks gives serious handloaders a die that fits their rifle rather than the other way around. Talk with your gunsmith before ordering to confirm they are set up to do the chambering work.
No, this is an unchambered blank. The bore and pilot holes are already finished, but the chamber still needs to be cut with your reamer by a competent gunsmith. It is intentionally made long so it can be trimmed to the correct final length once that work is done.
No. This is a hand-die design meant for an arbor press, and it can also be run with a soft-faced mallet. It is not built to thread into a conventional reloading press like a 7/8-14 die.
The micrometer top gives you precise seating depth adjustment in .001 inch graduations with an easy-to-read scale. You can record your setting, dial it back in, and get repeatable results, which is a real advantage during load development when testing bullet seating depth.
The chamber-type design fully captures both the case and bullet inside the die body, pushing the bullet straight down with a close-fitting stem while the case stays put. That setup tends to produce lower runout and better concentricity than conventional dies that rely on sliding collars, which is why it is popular with precision handloaders and wildcat shooters.
| UPC | 815145029928 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | SCB-70 |
You must be logged in to post a review.
Reviews
There are no reviews yet.