$79.20
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Precision handloaders know that how a bullet goes into the case matters just as much as the powder charge behind it. The L.E. Wilson 7mm-08 Remington Bullet Seating Die takes a different approach than the threaded dies most people start with. Instead of running the case up into the die, the case sits inside a chamber that's cut to match the 7mm-08 cartridge, and the bullet gets pressed straight down through a close-fitting seating stem. The result is excellent bullet-to-case alignment and the consistent, low-runout seating that serious precision loaders are after. Every one of these seaters is hand reamed to correct headspace, which is a big part of why they've earned their reputation.
This is what's called a hand die, meaning it runs with an arbor press rather than a conventional threaded reloading press. The workflow is straightforward: set your charged case in the die, drop a bullet on the case mouth, slide the die onto its base, and press the cap down until it bottoms out. Because the case and bullet are completely captured inside the die before anything moves, the bullet goes in dead straight every time. A lot of folks run these with a small arbor press like the K&M or L.E. Wilson's own press, and in a pinch you can even seat with a soft-faced mallet. Seating depth gets dialed in by turning the screw inside the cap.
The chamber-type design is a longtime favorite at the bench for one simple reason: it works more accurately than a standard 7/8-14 threaded seating die. By positively controlling both bullet and cartridge case alignment, it keeps runout to a minimum, and for a cartridge like the 7mm-08 that rewards precision loads out of a bolt gun, that edge adds up on paper. These seaters are machined from quality steel and built to hold their adjustment load after load. If you're building match-grade 7mm-08 ammo and want tighter concentricity than your press can give you, this die belongs on your bench.
No, this is a hand die designed to run with an arbor press rather than a conventional threaded press. Most loaders pair it with a small arbor press like the K&M or L.E. Wilson's own press for smooth, repeatable seating. In a pinch you can also seat bullets with a soft-faced mallet, though an arbor press gives you far better feel and control.
The case and bullet are completely captured inside a chamber cut to match the 7mm-08 cartridge before the bullet is pushed straight down by the seating stem. That positive control over alignment keeps runout low and produces more consistent concentricity than a conventional 7/8-14 threaded seating die. It's a big reason this style is a longtime favorite among benchrest and precision loaders.
This is the standard polished steel version with a seating cap that adjusts by turning the screw inside the cap. L.E. Wilson does offer micrometer-top stainless versions separately if you want faster, dial-in-style depth adjustments. For most loaders the standard cap handles seating depth precisely with a quick caliper check.
Seating depth is controlled by the screw inside the cap, so you turn it in or out to raise or lower where the bullet stops. A common method is to seat a bullet long, measure it, then screw the stem in the exact amount you want to go deeper and verify with calipers. Once it's dialed in, it holds that setting for consistent results round after round.
| UPC | 815145021854 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BS70-080 |
You must be logged in to post a review.
Reviews
There are no reviews yet.