$17.60
4 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you run an L.E. Wilson case trimmer and load for the 7.5×55 Swiss (also known as the 7.5mm Schmidt-Rubin), this is the case holder that keeps your brass prep tight and consistent. It's the fired-case version, machined with a slightly larger internal taper so your neck-sized brass sits with the case mouth protruding just right for trimming. The holder grips the case by its body taper rather than the case head, which is the whole reason Wilson gear earns its reputation for concentricity.
The inside of this holder is cut to mimic a firearm chamber, cradling the full body of the case so everything stays in perfect axial alignment with the cutter. That means square cuts and uniform case lengths pass after pass. Loading the case is simple: drop it in, do your work, then tap the case mouth to release it. No cross-pin, no fuss, just a clean press-fit that holds the brass steady.
This isn't a one-trick tool. The same holder works for primer pocket reaming, neck reaming, and deburring when paired with Wilson's Uniform Deburring tool. So once you've got it on the bench, it earns its keep across multiple steps of your case prep routine for the 7.5×55 Swiss.
Worth knowing the difference before you buy. The fired-case holder is sized for brass that's been neck sized. If you're running full-length sized or brand new brass, Wilson also offers a new-case holder (NCH-7555) that's cut a touch tighter. Plenty of handloaders find the fired version handles everything their chamber throws at it, but if your brass is on the smaller side after sizing, the new-case holder may seat it better. Made in the USA and built to the standard that keeps Wilson tools on serious benches for decades.
This is the fired-case version, cut with a slightly larger internal taper for neck-sized brass. For new or full-length sized cases, Wilson makes a dedicated new-case holder (NCH-7555) that's machined a bit tighter. That said, many reloaders find the fired holder works fine with their resized brass as long as the case mouth still clears the front for trimming, which can depend on your chamber and sizing dies.
It's designed for L.E. Wilson case trimmers and keeps the case in perfect axial alignment with the cutter head. Beyond trimming, you can use it for primer pocket reaming, neck reaming, and deburring with Wilson's Uniform Deburring tool. One holder covers several steps of your case prep for this cartridge.
The holder grips the brass by its body taper, cradling it much like the chamber of a firearm, which is what delivers those square, concentric cuts. You simply drop the case in, do your work, then tap the case mouth to pop it back out. It's a quick press-fit setup with no cross-pin to deal with.
Yes. The 7.5×55 Swiss and the 7.5mm Schmidt-Rubin are the same cartridge, so this holder covers both names. If your brass is headstamped for either, the CH-7555 is the correct fired-case holder for it.
| UPC | 815145027955 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | CH-7555 |
You must be logged in to post a review.
Reviews
There are no reviews yet.