Description
Benchrest and precision shooters have leaned on the 6mm PPC for decades because it rewards attention to detail, and this Redding Type S die is built for exactly that kind of handloader. It sizes the full body of the case, bumps the shoulder, and controls neck tension all in one stroke, while interchangeable bushings let you dial in how much the neck gets worked. The result is brass that lasts longer and ammo that comes out more consistent round after round.
What Sets the Type S Bushing Die Apart
Most standard dies squeeze the neck down too far, then yank it back open over an expander ball, which overworks the brass twice on every cycle. The Type S approach skips that. You pick a bushing sized to match your loaded round, so the neck only gets touched once and only as much as it needs. Bushings come in .001 inch increments, so you can tune neck tension to taste, typically landing somewhere between .001 and .003 inch under your loaded diameter. Changing brass brands or neck wall thickness just means swapping a bushing rather than buying a whole new die.
Flexibility Built Into This 6mm PPC Die
The bushing floats inside the die body and self-centers on the case neck, which helps keep runout low and concentricity tight. An adjustable decapping rod lets you set how much of the neck length gets sized, so partial neck sizing is on the table if you want it. The die ships with both a standard sizing button and a decapping pin retainer. Run the button for brass that hasn't been neck turned, or drop in the retainer and skip the expander entirely if you turn your necks. Pull the bushing and internals and it even doubles as a body die.
Getting the Most From Your Redding Type S Die
Keep in mind that bushings and the shellholder are sold separately, so you'll want to measure a few loaded rounds and order bushings to match before your first session. A light case lube and a clean die go a long way toward smooth, consistent sizing. For anyone chasing tight groups out of a 6mm PPC, this is the kind of tool that earns its keep at the loading bench.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 77319
- UPC: 611760773198
- Cartridge: 6mm PPC
- Die Style: Type S Bushing Full Length Sizing Die
- Bushing Increments: .001 inch
- Decapping Rod: Adjustable
- Thread: 7/8-14
- Country of Manufacture: United States
- Quantity: 1 die
What’s Included
- One Redding Type S Bushing Full Length Sizing Die
- Decapping rod
- Standard sizing button
- Decapping pin retainer
- Instruction sheet
Frequently Asked Questions
Do bushings come with the Redding Type S 6mm PPC die?
No, bushings are sold separately so you can match them to your specific brass. Measure a few loaded 6mm PPC rounds, then choose a bushing sized about .001 to .003 inch under that loaded neck diameter. Redding offers them in .001 inch increments in both plain steel and titanium nitride.
Is a shellholder included with this die?
No, the shellholder is sold separately. You'll want the correct shellholder for the 6mm PPC case head before you start sizing. If you already load other PPC or similar small-head cartridges, there's a good chance you have what you need on hand.
What is the advantage of a bushing die over a standard full length die?
A standard die sizes the neck down too far and then reopens it over an expander, working the brass twice every cycle. The Type S bushing die sizes the neck only once and only as much as needed, which extends case life and lets you fine tune neck tension. For precision work like 6mm PPC, that control translates to more consistent ammo.
Can this Type S die be used without the sizing button?
Yes. For brass that has been neck turned, swap in the included decapping pin retainer and run the die without the expander button. For brass that hasn't been turned or sorted by wall thickness, the standard sizing button is the recommended setup.




Reviews
There are no reviews yet.