$79.20
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The L.E. Wilson 6mm BR bullet seating die is built for reloaders who care about every thousandth of an inch. Instead of relying on a sliding sleeve like a conventional seater, this chamber type design captures both the case and the bullet inside a precisely machined cavity before anything moves. The case stays put while a close-fitting seating stem presses the bullet straight down into the neck, which is the whole secret behind the tiny runout numbers these dies are known for.
There's no shellholder and no threading into a standard press. You set a charged, primed case with a bullet balanced on the mouth into the die body, drop it on the base, and apply steady downward force. Most folks run it with an arbor press for smooth, repeatable strokes, though a soft-faced mallet or even firm hand pressure will get the job done in a pinch. That setup makes it a great option for seating at the bench or doing load development right at the range. Seating depth is dialed in with the cap screw on top, which uses 3/8 inch to 24 TPI threads for fine control. Seat a bullet long, measure, then turn the stem in a touch at a time until you hit your number.
This one is machined entirely from stainless steel for strength and a long service life, and each unit is reamed to proper headspace so the fit stays tight. Reloaders who run these regularly report concentricity that holds within a thousandth or two, which is exactly what you want when you're loading for accuracy in a precision 6mm BR rig. For load testing, competition prep, or high-precision hunting ammo, it's one of the most trusted seaters out there.
A quick tip from experienced users: stick with the standard seating stem for conventional bullet shapes, and consider a VLD stem separately if you're loading long, pointed match bullets. Giving the top cap a gentle spin as the bullet settles into the cone can help center things up and tighten your runout even further.
No, this is a hand die, not a 7/8-14 threaded press die. It's designed to be used with an arbor press, and it can also be operated with a soft-faced mallet or firm hand pressure. Many reloaders prefer an arbor press for smooth, repeatable seating strokes.
No, this is the standard cap screw version, not the micrometer-top model. You adjust seating depth using the cap screw with 3/8 inch to 24 TPI threads. A good method is to seat a bullet long, measure it, then turn the stem in a little at a time until you reach your desired depth.
No shellholder is required. The case sits with its base against the die's base, and the die body fully captures both the case and bullet before seating. That chamber type capture is what keeps everything aligned and produces the low runout these dies are known for.
The die ships with the standard seating stem, which works great for conventional bullet profiles. If you're loading long, pointed VLD bullets, a dedicated VLD seating stem is available separately and tends to improve seating depth consistency with those shapes. For most 6mm BR loads, the included stem gets the job done.
| UPC | 815145021755 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BS60-BR |
You must be logged in to post a review.
Reviews
There are no reviews yet.