$135.00
3 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
A baffle strike is one of the more expensive mistakes you can make with a suppressed rifle, and the frustrating part is that it usually starts with a mounting issue you never saw coming. The Geissele 6.5mm Suppressor Alignment Gage (SAG) exists to catch that problem while your rifle is still on the bench. Slide the rod down the bore and through the suppressor, and you get a clear read on whether everything is concentric. If the gage passes clean through the exit hole without dragging or hanging up, you're good to go.
Here's the thing about suppressor alignment: the mounting interface at the muzzle is short, but the can hanging off it is long. A tiny deviation at the threads or the muzzle device gets multiplied by the time it reaches the endcap, and small errors can stack on top of each other. That's why a straight, well-made gage matters. Geissele grinds this rod 0.002 inch under nominal bore diameter, which testing has shown fits the widest range of real-world barrels, and holds it straight to 0.001 inch over its full length. The rod's length is what does the aligning, so it self-centers in the bore without needing a tight, fussy fit.
The SAG is machined from hardened steel, and that hardening is more than a durability checkbox. It keeps abrasive powder residue from wearing the surface, prevents the rod from picking up burrs if it contacts a misaligned baffle, and stops grit from embedding in the gage itself. In other words, the tool stays accurate check after check, rifle after rifle.
If you're running a can on a 6.5 Creedmoor, 6.5 Grendel, or any other 6.5mm bore, this is the version you want. It's a smart check any time you install a new muzzle device, swap mounts, pick up a fresh suppressor, or just want peace of mind before a match or hunt. A few seconds with this rod beats a ruined can and a trip back to the manufacturer every single time.
With the firearm confirmed unloaded and the suppressor mounted, slide the rod down the bore from the muzzle end and let it pass through the suppressor. Because the rod is long and precision ground, it self-aligns to the bore. If it exits the endcap cleanly without contacting baffles or the exit hole, your alignment checks out. Any rubbing or hang-up means you should pull the setup apart and find the problem before shooting.
Yes, the 6.5mm SAG is sized for 6.5mm bores, which covers 6.5 Creedmoor, 6.5 Grendel, 6.5 PRC, .260 Remington, and similar cartridges. Geissele grinds the rod 0.002 inch under nominal bore diameter, a size they found fits the widest variety of barrels while still giving an accurate alignment read.
Nope, and that's by design. Barrel bore diameters and straightness vary more than most folks realize, so a rod ground 0.002 inch under nominal fits nearly all barrels. The rod's long length is what aligns it to the bore, so a super tight fit isn't necessary for a reliable reading.
Yes, each gage is sized to a specific bore diameter, so you'll want the matching version for each caliber you run suppressed. Geissele makes the SAG in a range of sizes including 5.56mm, 6mm, 6.8mm, 7.62mm, 9mm, .375, 5.45mm, .408, and .50, so there's one for just about every suppressed setup.
| UPC | 810081131827 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 10-448-F |
You must be logged in to post a review.
Reviews
There are no reviews yet.