$79.20
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you've chased tighter groups and wondered where your concentricity was slipping away, the seating step is often the culprit. The L.E. Wilson 30-06 Springfield bullet seating die takes a different approach than your typical threaded press die. Instead of relying on press alignment, the die itself has a chamber cavity that mimics your rifle's chamber, fully capturing the case and the bullet before the bullet is pushed straight into the case mouth by a close-fitting seating stem. The result is remarkably straight ammo with minimal runout, which is exactly why this style has been a favorite on the benchrest line for years.
This is an inline seater designed to run in an arbor press, with only one moving part during the actual seating operation. That simplicity is the whole point. The seating stem and guide hole are machined to extremely tight tolerances, so the bullet sits dead center as it enters the case. It's turned from a solid bar of high-grade steel rather than cast, and each one is hand reamed to the correct headspace before it leaves the shop. That hands-on fitting is a big part of why these are considered some of the most consistent seaters you can buy.
Seating depth adjustments are made by turning the screw inside the cap, which uses a 3/8-24 thread. A handy trick with this version is to pull the cap and stem and measure the stem height with calipers before and after an adjustment, so you know exactly how much you moved your depth. It's a clean, repeatable way to work toward your rifle's sweet spot.
Built in the USA and compact enough to toss in a range bag, this Wilson seater is a smart pickup for the 30-06 handloader who cares about precision over speed.
Yes, this is an inline chamber type seater designed to be used in an arbor style press. The case and bullet sit in the die body and are pressed together by the arbor press ram. It's the standard setup for benchrest and precision handloaders who run Wilson dies.
No, this is the standard version. Seating depth is set by turning the adjustment screw inside the cap, which uses a 3/8-24 thread. If you want click adjustments in thousandths, Wilson offers a separate micrometer top model, but this standard seater still gives you very repeatable results with a little calipers work.
The die has a chamber cavity that holds the case and bullet in alignment before seating ever begins, rather than depending on your press for alignment. A close-fitting seating stem then pushes the bullet straight into the case mouth. That full capture is what keeps runout low and concentricity high.
The standard die ships with a conventional seating stem that works well with most common 30 caliber bullets. For long, pointed VLD and hybrid bullets, Wilson sells a separate VLD seating stem that matches the ogive better. Swapping stems is simple if you decide you need it down the road.
| UPC | 815145021403 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BS30-060 |
You must be logged in to post a review.
Reviews
There are no reviews yet.