Description
If you're handloading for a bolt-action 260 Remington and chasing every last bit of accuracy, this is the tool that gets you there. The Lee Precision Collet Neck Sizing Die uses a steel collet to press the fired case neck against a precision-ground mandrel. That squeeze straightens the neck and keeps runout to a minimum, which is exactly what you want when a round chambers true and the bullet sits dead center.
Because it only works the neck and leaves the case body alone, your brass stays fire-formed to your own chamber. That preserved fit is what delivers consistency round after round, and it's also why neck-sized brass tends to last far longer than cases run through a full-length die. One of the nicest perks here is that you can skip the case lube entirely. No sticky brass, no cleaning gunk off every case, just a quick pass and you're done.
How the 260 Remington Collet Die Earns Its Keep
The collet design asks very little of your press. It takes light effort to run a stroke, and there's a short setup process where you adjust the die down in small increments until you hit the neck tension you're after. Once you dial it in, it's repeatable and clean. The die threads into any standard reloading press with the common 7/8-14 thread, so it drops right into your existing setup.
Who Should Reach for This Collet Neck Sizer
Neck sizing is built for single-chamber use. These results come from loading brass that was fired in the same rifle it'll go back into, so it's a match made for bolt guns. It isn't the right call for autoloaders, slide actions, or lever guns, where a full-length die is the better fit. For the precision-minded 260 Rem reloader running a bolt rifle, though, this die is a straightforward path to tighter groups and longer-lived brass.
Key Specifications
- Manufacturer: Lee Precision
- Caliber: 260 Remington
- Die Type: Collet Neck Sizing Die (die only)
- Thread Size: 7/8-14
- Collet Material: Steel
- Case Lube Required: No
- Recommended Use: Bolt-action rifles only
- Manufacturer Part Number: 91008
- UPC: 734307910082
What’s Included
- Steel collet neck sizing die (.260 Remington)
- Custom-fit plastic storage container
Frequently Asked Questions
Do I need case lube with the 260 Remington collet neck sizing die?
No, you don't. The collet design sizes the neck by squeezing it against a mandrel rather than pulling the case through a sizing ring, so lubrication isn't needed. That keeps your brass clean and skips the cleanup step entirely.
Can I use this die for brass fired in different rifles?
It's meant for cases fired in the same rifle you'll load them back into. Neck sizing preserves the fire-formed fit of the case to your chamber, which is where the accuracy and extended brass life come from. If you're loading brass to shoot across multiple guns, a full-length sizing die is the better choice.
Is this collet die a complete die set?
No, this is the collet neck sizing die only. You'll still need a seating die, a shell holder, and load data to finish out your reloading process. If you'd rather have everything in one box, Lee also offers a 260 Remington collet two-die set.
Will the Lee collet die fit my press?
Yes, it uses the standard 7/8-14 thread found on virtually all common reloading presses. It threads right in alongside your other dies with no special adapters. There's a brief setup to dial in your neck tension, and after that it's quick and repeatable.



Reviews
There are no reviews yet.