Description
The Redding Type S Full Length Bushing Die for 25 Creedmoor gives handloaders something standard dies can't: the ability to size the whole case while controlling neck tension on its own terms. Instead of forcing every neck down to a one-size-fits-all diameter, this die uses an interchangeable bushing that you select to match your brass. That means you decide how much the neck gets worked, which keeps runout low and extends the life of your case necks. The reason this matters is simple. Most brass runs thicker than the minimum spec dies are built around, so a conventional die tends to oversize the neck and introduce stress and concentricity problems. The Type S approach sidesteps that whole issue.
How the 25 Creedmoor Type S Die Earns Its Keep
Bushings are available in .001-inch increments and are the same interchangeable bushings used across Redding's bushing-style neck dies, so you can fine-tune neck tension right down to the thousandth. The bushing is free-floating, which lets it self-center on the case neck for a higher degree of sizing accuracy. You size the body, set your shoulder bump, and control the neck all in one stroke on the press.
Setup and Versatility
The adjustable decapping rod lets you move the bushing position so you can size only part of the neck length when you want to. It ships with both a standard size button and a decapping pin retainer, so folks who neck-turn their brass for uniformity can skip the button entirely and size externally only. There's a nice bonus here too: pull the bushing and the internal parts, and the die works as a body die.
This is a precision reloading tool aimed at the 25 Creedmoor crowd running everything from bolt guns to modern sporting rifle platforms. One thing worth knowing before you order: the die does not come with bushings or a shellholder, so you'll want to grab the correct bushing for your brass and a #1 shellholder to go with it.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 77960
- UPC: 611760779602
- Caliber: 25 Creedmoor
- Die Type: Type S Full Length Bushing Sizing Die
- Bullet Diameter: .257
- Bushing Adjustment: .001-inch increments (bushings sold separately)
- Shellholder: #1 (sold separately)
- Thread: 7/8"-14
- Doubles As: Body die when bushing and internals are removed
What’s Included
- One Redding 25 Creedmoor Type S Full Length Bushing Sizing Die
- Adjustable decapping rod
- Standard size button
- Decapping pin retainer
- Die storage box
- Instructions
Frequently Asked Questions
Does the 25 Creedmoor Type S die come with bushings?
No, the die ships without bushings and they're sold separately. This is by design, since the bushing you need depends on your brass wall thickness and the neck tension you're after. Pick one in .001-inch increments, and if your brass hasn't been neck-turned, a good rule is to measure a loaded round and choose a bushing roughly .003 to .005 inch under that diameter.
Do I need a shellholder with this die?
Yes, a shellholder is required and not included. For 25 Creedmoor you'll want a standard #1 shellholder. It's a small add-on but essential to run the die on your press.
Can the Redding Type S Full Length die be used as a body die?
It can. Remove the bushing and all the internal parts, and the die functions as a body die that sizes the case body and bumps the shoulder without touching the neck. That makes it a flexible single tool for folks who also neck-size separately.
What's the advantage of a bushing die over a standard full length die?
A standard die sizes the neck to a fixed diameter, which often overworks brass since most cases run thicker than the spec the die was built around. The Type S lets you choose exactly how much the neck gets sized, which cuts down on stress and runout. The free-floating bushing also self-centers on the neck for better concentricity in your finished rounds.




Reviews
There are no reviews yet.