Description
Neck tension is one of those little details that separates good handloads from great ones, and this .247" Hornady Match Grade Bushing is how you take control of it. It drops into a Hornady Match Grade bushing-style sizing die and sizes your case necks to a precise diameter, giving you repeatable bullet grip load after load. If you've been chasing better consistency on paper, getting your neck tension dialed in is one of the best places to start.
Why the .247" Match Grade Bushing Matters
A bushing sizing system only works on the part of the neck that actually needs it, so you're not slamming the whole neck down and springing it back out with an expander ball. The self-centering design keeps everything aligned and cuts down on the overworking that leads to split necks and short case life. Less working of the brass means your cases last longer and your necks stay more uniform, which shows up as tighter groups down range.
Picking the Right Bushing Size
Most reloaders land on a bushing size by measuring the outside neck diameter of a loaded round and subtracting roughly .002" to .003" for their desired tension, which leaves about .001" of spring-back built in. A common starting point for precision rifle work is about .002" of neck tension, with heavier or magazine-fed loads often running closer to .003". Since results vary with your exact brass and neck wall thickness, a lot of folks keep a bushing one size above and one below their target so they can fine-tune on the bench.
Built to Fit Your Match Grade Setup
This .247" bushing is part of Hornady's lineup that steps through sizes in small increments, so you can hone in on the exact neck tension your rifle likes. It's a self-centering, interchangeable piece designed to run in Hornady Match Grade bushing dies. One bushing is a small investment toward noticeably more consistent ammo.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number (MPN): 594247
- UPC: 090255592474
- Bushing Diameter: .247"
- Type: Self-Centering Neck Size Bushing
- Compatibility: Hornady Match Grade Bushing Dies
- Quantity: 1 bushing
- Application: Rifle Neck Sizing
- Shipping Weight: 0.25 lb
What’s Included
- One (1) Hornady .247" Match Grade Bushing
Frequently Asked Questions
What dies does the .247" Match Grade Bushing work with?
It's designed to run in Hornady Match Grade bushing-style sizing dies. Because these bushings share the common neck sizing bushing footprint, many reloaders find them interchangeable with other bushing dies on the market as well. If you're unsure about your specific die, check your die's bushing bore dimension before ordering.
How do I know if .247" is the right bushing size for my brass?
The usual method is to measure the outside neck diameter of a loaded round, then subtract about .002" to .003" for your desired neck tension, which accounts for roughly .001" of brass spring-back. Since neck wall thickness varies by brass brand, the exact size can shift a thousandth or two. Many reloaders keep a bushing one size up and one down so they can tune it in on the bench.
Does a bushing die reduce how much I'm working my brass?
Yes, that's one of the main benefits. The self-centering design sizes only the neck area and avoids the over-sizing you get when you pull a case up over a traditional expander ball. Working the brass less means longer case life and more consistent neck tension round to round.
Is this bushing sold individually?
Correct, this is a single .247" bushing. Hornady offers these in small diameter increments so you can build out a set and dial in exactly the neck tension your rifle shoots best.





Reviews
There are no reviews yet.