Description
If you're running a Forster bushing die and want to control exactly how much grip your brass has on the bullet, this .287" neck bushing is the piece that makes it happen. Forster offers these in .001" increments, so you can fine-tune neck tension to your brass and your rifle instead of settling for whatever a standard die hands you. This is one bushing only and the die is sold separately.
What the .287" Forster Neck Bushing Does on the Bench
Drop it into a Forster Bushing Bump Neck Sizing Die or a Bushing Full Length Sizing Die and the bushing determines the inside diameter of your sized case neck. That means you set the amount of bullet tension yourself, which is where a lot of accuracy and brass life comes from. Because the bushing only sizes the neck down to the diameter you pick, your brass gets worked less than it would with a conventional full-length die, and that tends to pay off in longer case life and less frequent annealing.
Why the Cryo Treatment on This Neck Bushing Matters
Forster heat treats and hones each bushing to the stated inside diameter, then runs it through a cryogenic process that refines and smooths the steel surface. A slicker bushing sizes brass more cleanly, and cleaner sizing means less runout and straighter loaded rounds coming off the press. These are honed to the precise .287" inside diameter, so you know what you're getting before it ever touches a case.
Picking the Right Size
Most handloaders measure the outside neck diameter of a loaded round and subtract .002" to .003" for their bushing size, which accounts for a little brass spring-back and sets a solid starting neck tension. Many reloaders keep one size above and one below their target on hand so they can adjust as brass hardens or they switch lots. Worth noting: Forster bushing dies only accept Forster bushings, so these won't swap into Redding or Wilson dies.
Key Specifications
- Manufacturer: Forster Products
- Manufacturer Part Number: BUSH-287
- UPC: 757253997983
- Inside Diameter: .287 in
- Material: Cryogenically treated steel
- Type: Neck sizing bushing
- Compatibility: Forster Bushing Bump Neck Sizing Dies and Bushing Full Length Sizing Dies
- Sizing Increments Available: .001 in
- Country of Origin: USA
What’s Included
- One Forster .287" neck bushing (BUSH-287)
Frequently Asked Questions
What dies does the Forster .287" neck bushing fit?
It's designed for Forster's Bushing Bump Neck Sizing Dies and Bushing Full Length Sizing Dies. Forster bushing dies only accept Forster bushings, so this one will not work in Redding or Wilson die bodies. The die itself is sold separately from the bushing.
How do I know if .287" is the right bushing size for my brass?
A common method is to measure the outside neck diameter of a loaded round with a caliper or micrometer, then subtract .002" to .003" to get your bushing size. That subtraction accounts for brass spring-back and sets your neck tension. If a loaded round measures around .289" to .290" at the neck, .287" lands in the typical range.
Is the die included with this neck bushing?
No, this listing is for a single .287" bushing only. You'll need a Forster Bushing Bump or Bushing Full Length Sizing Die to use it. Many handloaders keep several bushing sizes on hand so they can adjust neck tension as their brass work-hardens or they change lots.
Why is the Forster neck bushing cryogenically treated?
After heat treating, Forster runs each bushing through a cryogenic process that refines and closes the steel's surface for a smoother finish. A slicker bushing sizes brass more cleanly, which helps reduce runout and produce straighter loaded rounds. Each one is honed to the precise stated inside diameter.




Reviews
There are no reviews yet.