$299.99
6 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The LaRue LT913 in-line mount is a one-piece, no-nonsense platform for anyone running a 30mm optic who wants their scope sitting straight over the rail instead of pushed forward like a cantilever. It sets your optic centerline at 1.535 inches above the rail, which lands right in the sweet spot for a natural cheek weld on flat-top rifles and bolt guns alike. The 20 MOA of built-in cant is the real story here, giving you extra elevation range so you can dial way out without running your turret to the top of its travel.
This one skips the forward cantilever and keeps the rings inline, which makes it a clean fit for setups where you don't need the optic pushed out over a handguard. Because it's a single piece cut from bar-stock aluminum and finished with a tough hardcoat anodize, there's no ring-to-ring misalignment to fight and no lapping to deal with. The rings clamp with even pressure so your scope tube stays protected, and the whole thing shrugs off recoil and rough handling.
LaRue built its name on QD mounts, and the LT913 uses the same Speed Lever system found across their lineup. Pull the levers, lift the optic off, and drop it back on later without chasing your zero all over the target. Folks who run these consistently report groups landing right back where they left them after a remount, which is the whole point of a quality QD.
The LT913 clamps to any Mil-Std 1913 Picatinny rail and is sized for 30mm scope tubes. If your optic has a 34mm main tube, LaRue makes the LT913 in that ring size too, so double-check your scope's tube diameter before ordering. Made in the USA, this mount is the kind of piece you buy once and forget about.
This version of the LT913 is machined for 30mm scope tubes and clamps to any Mil-Std 1913 Picatinny rail. If your optic has a 34mm main tube, LaRue offers the LT913 in that ring size as well. Always confirm your scope's tube diameter before ordering so you get the right fit.
Yes. The LT913 uses LaRue's Speed Lever QD system, which is built for repeatable return to zero. Users who remove and remount their optics regularly consistently report their groups landing right back on target, which is exactly what a quality QD mount should do.
The 20 MOA of built-in cant tilts the optic slightly forward, giving you additional elevation range for long-distance shooting. That means you can dial out to distance without running out of adjustment in your scope's turret. It's a popular choice for anyone pushing their rifle past a few hundred yards.
A cantilever mount pushes the optic forward over the handguard to help with eye relief, while the in-line LT913 keeps the rings positioned straight over the rail. The in-line style is a clean choice for setups that don't need the forward reach, like many bolt guns and rifles with plenty of rail real estate.
| UPC | 810143183986 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | LT913-1.535-20-30 |
You must be logged in to post a review.
Reviews
There are no reviews yet.