$11.99
Out of stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
A threaded barrel is a great thing to have, but those fine 1/2×28 threads and the crown behind them are more delicate than most folks realize. One drop onto a workbench or a little bit of pocket grit is all it takes to ding a thread or nick the crown, and once that happens your suppressor or comp won't seat right. Noveske built this thread protector to take that worry off the table when you're carrying, storing, or shooting your 9mm without a can attached.
This one carries the same build quality Noveske puts into the rest of their lineup. The body wears a knurled diamond pattern that gives you plenty of grip to snug it down by hand, no wrench needed, and the black finish keeps it looking clean while shrugging off wear. It threads onto any standard 1/2×28 muzzle, which is the common pitch you'll find on aftermarket 9mm pistol barrels and a lot of .22 setups too.
A lot of bare thread protectors have a habit of backing off under recoil or vibration. Noveske includes an o-ring that seats into the protector, adding just enough tension to hold it in place so it doesn't rattle loose on you at the range or work its way off in your bag. It's a small detail, but it's the kind of thing that separates a protector you can trust from one you're constantly re-tightening.
Think of this as cheap insurance for an expensive barrel. When the suppressor comes off for cleaning or storage, this cap covers your crown and threads so gravity, dust, and the occasional bump don't cost you accuracy or a headache down the road. Machined to fit right and finished to last, it's the kind of small part that quietly earns its keep every time you handle your pistol.
It fits any barrel cut with the standard 1/2×28 thread pitch, which is the common pattern on aftermarket 9mm pistol barrels. Just double check your barrel is actually threaded 1/2×28 and not a metric pitch like 13.5×1 LH, which some factory European barrels use. If yours is the standard US 1/2×28, this will thread right on.
Yes, Noveske includes an o-ring that seats into the protector. That o-ring adds tension against the threads so the protector holds firm and doesn't rattle loose under recoil or vibration. You can snug it down by hand thanks to the knurled body, no tools required.
A thread protector is meant to guard your threads and crown when no muzzle device or suppressor is attached. Whether you leave it on while shooting comes down to your setup and personal preference, but its main job is protecting the barrel during storage, transport, and everyday handling. When you mount a can or comp, the protector comes off and gets set aside.
Exposed muzzle threads and the crown behind them are easy to damage from drops, debris, and abrasion. A single ding on the crown can throw off accuracy, and buggered threads can keep a suppressor or comp from seating correctly. This cap covers both so your barrel stays ready to run.
| UPC | 840906138755 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 05002705 |
| Caliber/Gauge | 9mm |
| Color | Black |
| Model | |
| Product Type | Thread Protector |
You must be logged in to post a review.
Reviews
There are no reviews yet.